The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during luggage compartment door removal/installation are shown below.
64719A
1.REMOVE LUGGAGE COMPARTMENT DOOR COVER
Using a clip remover, remove the 13 clips and luggage compartment door cover.
74649
2.REMOVE LUGGAGE COMPARTMENT DOOR ASSIST GRIP
Disengage the 2 claws and guide.
Remove the 2 screws and luggage compartment door assist grip.
64572
3.REMOVE LUGGAGE COMPARTMENT DOOR HINGE COVER LH
Remove the 2 clips and luggage compartment door hinge cover LH.
64571
4.REMOVE LUGGAGE COMPARTMENT DOOR HINGE COVER RH
Remove the 2 clips and luggage compartment door hinge cover RH.
64610
5.REMOVE LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY
6.REMOVE LUGGAGE COMPARTMENT DOOR LOCK CYLINDER ASSEMBLY
Remove the 2 nuts and luggage compartment door lock cylinder assembly.
81590A
7.REMOVE REAR LIGHT ASSEMBLY LH
81580D
8.REMOVE REAR LIGHT ASSEMBLY RH
Use the same procedure as for the LH side.
76813A
9.REMOVE NO. 3 LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH
76801A
10.REMOVE LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY
84945
11.REMOVE LUGGAGE ELECTRICAL KEY SWITCH
81270
12.REMOVE LICENSE PLATE LIGHT ASSEMBLY (for LH Side)
81270
13.REMOVE LICENSE PLATE LIGHT ASSEMBLY (for RH Side)
Use the same procedure as for the LH side.
14.REMOVE REAR TELEVISION CAMERA ASSEMBLY WITH WIRE (w/ Rear View Monitor System)
64459
15.REMOVE LUGGAGE COMPARTMENT DOOR CUSHION
Disengage the 8 claws to remove the 2 luggage compartment door cushions.