Home › Vehicle Exterior › LIGHTING (EXT) › FOG LIGHT ASSEMBLY › 2018.04–2021.02
RM33A0E _59 Vehicle Exterior _065395 LIGHTING (EXT) _0327018 FOG LIGHT ASSEMBLY A

LIGHTING (EXT)  FOG LIGHT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fog light assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly (w/ Panoramic View Monitor System) Front television camera view adjustment Panoramic View Monitor System (Click here)

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

Hide 81220 2.REMOVE FOG LIGHT ASSEMBLY

a.

for Bar Type Radiator Grille:

i.
E371295

Remove the 3 screws and fog light assembly.



b.

for Mesh Type Radiator Grille:

i.
E378078

Remove the 3 screws and fog light assembly.