The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during engine unit removal/installation are shown below.
13715
1.REMOVE EXHAUST VALVE
Using SST, compress the compression spring and remove the valve spring retainer lock.
Remove the valve spring retainer, compression spring and exhaust valve from the cylinder head sub-assembly.
Arrange the removed parts in such a way that they can be reinstalled to their original locations.
13711
2.REMOVE INTAKE VALVE
Using SST, compress the compression spring and remove the valve spring retainer lock.
Remove the valve spring retainer, compression spring and intake valve from the cylinder head sub-assembly.
Arrange the removed parts in the correct order.
13711E
3.REMOVE VALVE STEM OIL SEAL
Using needle-nose pliers, remove the 8 intake valve stem oil seals and 8 exhaust valve stem oil seals.
13734
4.REMOVE VALVE SPRING SEAT
Using compressed air and a Magnet Hand, remove the 16 valve spring seats by blowing air onto them.
11117E
5.REMOVE NO. 1 STRAIGHT SCREW PLUG
If coolant leaks from a No. 1 straight screw plug or a plug is corroded, replace it.
Using a 10 mm hexagon wrench, remove the 3 No. 1 straight screw plugs and 3 gaskets.
11117F
6.REMOVE NO. 2 STRAIGHT SCREW PLUG
If coolant leaks from the No. 2 straight screw plug or a plug is corroded, replace it.
Using a 14 mm hexagon wrench, remove the No. 2 straight screw plug and gasket.
17159
7.REMOVE STUD BOLT
If a stud bolt is deformed or its threads are damaged, replace it.
Using an E7 or E8 "TORX" socket wrench, remove the 5 stud bolts.