Home › Engine / Hybrid System › 2GR-FKS (COOLING) › WATER PUMP › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _065337 2GR-FKS COOLING _0326738 WATER PUMP A

2GR-FKS COOLING  WATER PUMP  REMOVAL  


PROCEDURE

Hide 16031 1.REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

Hide 16361A 2.REMOVE V-RIBBED BELT

Hide 16604 3.REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY

a.
A394888

Remove the bolt and No. 2 idler pulley sub-assembly.


Hide 16173 4.REMOVE WATER PUMP PULLEY

a.
A478643C02
0.917,2.302 1.063,2.302 1.063,2.302 1.198,1.625 true 2.417,2.667 2.25,2.667 2.25,2.667 2.031,1.885 true 1.708,0.917 1.99,0.573 1.99,0.573 2.146,0.573 true 2.427,2.583 2.677,2.771 0.25,0.188 10 true *a 0.729,2.229 0.917,2.406 0.188,0.177 10 true *b 2.156,0.5 2.385,0.656 0.229,0.156 10 true *c
*a Protective Tape
*b Hold
*c Turn


Using a screwdriver or equivalent with its tip wrapped in protective tape, hold the water pump pulley.


b.

Remove the 4 bolts and water pump pulley.


Hide 16100 5.REMOVE ENGINE WATER PUMP ASSEMBLY

a.
A407190

Remove the 15 bolts, engine water pump assembly and water pump gasket.