Home › Engine / Hybrid System › 2AR-FE (FUEL) › FUEL PRESSURE PULSATION DAMPER › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _065325 2AR-FE FUEL _0328390 FUEL PRESSURE PULSATION DAMPER A

2AR-FE FUEL  FUEL PRESSURE PULSATION DAMPER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel pressure pulsation damper assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)

CAUTION:
·
A360563

Never perform work on fuel system components near any possible ignition sources.

·

Vaporized fuel could ignite, resulting in a serious accident.


·
A360564

Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.

·

Sparks could cause vaporized fuel to ignite, resulting in a serious accident.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCHARGE FUEL SYSTEM PRESSURE

Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 12601B 4.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 17705 5.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 23901 6.DISCONNECT FUEL TUBE SUB-ASSEMBLY

a.
A405325C01
2.563,0.948 2.677,1.156 2.677,1.156 2.771,0.938 false 2.594,1.167 2.906,1.323 0.313,0.156 10 false *a
*a Claw


Disengage the 2 claws to remove the No. 2 fuel pipe clamp.


b.
A405902

Disconnect the fuel tube sub-assembly from the fuel delivery pipe.

SST
09268-21011  


c.

Disengage the clamp to disconnect the fuel tube sub-assembly from the fuel hose clamp.


Hide 23270 7.REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY

a.
A405903

Remove the 2 bolts and fuel pressure pulsation damper assembly from the fuel delivery pipe.


b.
A342985

Remove the O-ring from the fuel pressure pulsation damper assembly.