Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
69780B
1.INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY
|
Install in this Direction |
Install the rear door inside locking cable assembly as shown in the illustration.
69740D
2.INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY
|
Install in this Direction |
Install the rear door lock remote control cable assembly as shown in the illustration.
69038A
3.INSTALL REAR DOOR LOCK COVER SUB-ASSEMBLY
|
Install in this Direction |
Engage the 2 claws as shown in the illustration.
Engage the 2 claws to install the rear door lock cover sub-assembly as shown in the illustration.
69060A
4.INSTALL REAR DOOR LOCK WITH MOTOR ASSEMBLY
When reusing a removed rear door lock with motor assembly, replace the door lock wiring harness seal with a new one.
Do not allow grease or dust to adhere to the door lock wiring harness seal installation surface.
Reusing a door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water ingress. This may result in a malfunction of the rear door lock with motor assembly.
Apply MP grease to the sliding parts of the rear door lock with motor assembly.
When reusing the rear door lock with motor assembly:
Install a new door lock wiring harness seal to the rear door lock with motor assembly.
| *a | Release Plate |
|
Install in this Direction |
Connect the rear door lock with motor assembly to the release plate of the rear door outside handle frame sub-assembly, and set it to the rear door panel.
Make sure that the release plate of the rear door outside handle frame sub-assembly is securely connected to the rear door lock with motor assembly.
Using a T30 "TORX" socket wrench, install the rear door lock with motor assembly with the 3 screws.
68104
5.INSTALL REAR DOOR GLASS SUB-ASSEMBLY
68124B
6.INSTALL REAR DOOR QUARTER WINDOW GLASS
67408F
7.INSTALL REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY
67872
8.CONNECT REAR DOOR WEATHERSTRIP
Connect the rear door weatherstrip.
68152C
9.INSTALL REAR DOOR GLASS RUN
67858B
10.INSTALL REAR DOOR PANEL PROTECTOR
67848A
11.INSTALL REAR DOOR NO. 1 VENT SEAL
67842E
12.INSTALL REAR DOOR SERVICE HOLE COVER
67844A
13.INSTALL REAR DOOR NO. 2 SERVICE HOLE COVER
68174A
14.INSTALL REAR DOOR INNER GLASS WEATHERSTRIP
67604
15.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
74260
16.INSTALL REAR ARMREST ASSEMBLY
17.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL
74038B
18.INSTALL REAR DOOR ARMREST COVER SUB-ASSEMBLY
19.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
for 2AR-FE:
Click hereGeneral>MAINTENANCE>2AR-FE BATTERY>INSTALLATION
for A25A-FKS:
Click hereGeneral>MAINTENANCE>A25A-FKS BATTERY>INSTALLATION
for 2GR-FKS:
Click hereGeneral>MAINTENANCE>2GR-FKS BATTERY>INSTALLATION
for 6AR-FSE:
20.INITIALIZE POWER WINDOW CONTROL SYSTEM
21.INSPECT POWER WINDOW OPERATION