Home › Engine / Hybrid System › A25A-FKS (EMISSION CONTROL) › CANISTER (w/o Canister Pump Module) › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _065344 A25A-FKS EMISSION CONTROL _0344120 CANISTER(w/o Canister Pump Module) A

A25A-FKS EMISSION CONTROL  CANISTER(w/o Canister Pump Module)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during canister (fuel suction plate sub-assembly) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)
Replacement of fuel pump Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 77020A 1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

Hide 23070 4.REMOVE FUEL MAIN VALVE ASSEMBLY (for Low Pressure)

Hide 23070 5.REMOVE FUEL MAIN VALVE ASSEMBLY (for High Pressure)