Home › Engine / Hybrid System › A25A-FKS (FUEL) › FUEL FILTER (w/o Canister Pump Module) › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _065343 A25A-FKS FUEL _0341519 FUEL FILTER(w/o Canister Pump Module) A

A25A-FKS FUEL  FUEL FILTER(w/o Canister Pump Module)  REPLACEMENT  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel filter removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)
Replacement of fuel pump Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

CAUTION:
·
A360563

Never perform work on fuel system components near any possible ignition sources.

·

Vaporized fuel could ignite, resulting in a serious accident.


·
A360564

Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.

·

Sparks could cause vaporized fuel to ignite, resulting in a serious accident.



PROCEDURE

Hide 77020A 1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

Hide 23070 4.REMOVE FUEL MAIN VALVE ASSEMBLY (for Low Pressure)

Hide 23070 5.REMOVE FUEL MAIN VALVE ASSEMBLY (for High Pressure)

Hide 77174 6.REMOVE NO. 1 FUEL SUCTION SUPPORT

a.
A401688

for Type A:

i.

Remove the No. 1 fuel suction support fromthe fuel filter.



b.
A502659C02
1.125,0.76 1.25,0.24 1.25,0.24 1.406,0.24 true 1.448,0.146 1.76,0.302 0.313,0.156 10 false *a
*a Protective Tape


for Type B:

i.

Using a screwdriver with its tip wrapped withprotective tape, disengage the 2 claws andremove the No. 1 fuel suction support fromthe fuel filter.



Hide 77174 7.INSTALL NO. 1 FUEL SUCTION SUPPORT

a.

for Type A:

i.

Install the No. 1 fuel suction support to the fuel filter.



b.

for Type B:

i.

Engage the 2 claws to install the No. 1 fuel suction support to the fuel filter.



Hide 23070 8.INSTALL FUEL MAIN VALVE ASSEMBLY (for High Pressure)

Hide 23070 9.INSTALL FUEL MAIN VALVE ASSEMBLY (for Low Pressure)

Hide 77020A 12.INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY