Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER ACTUATOR › 2018.04–2021.02
RM33A0E _59 Vehicle Exterior _065394 WIPER / WASHER _0321231 HEADLIGHT CLEANER ACTUATOR A

WIPER / WASHER  HEADLIGHT CLEANER ACTUATOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during headlight washer actuator sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link
Front bumper assembly (w/ Panoramic View Monitor System) Front television camera view adjustment Panoramic View Monitor System (Click here)

PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

Hide 85354 2.REMOVE HEADLIGHT WASHER COVER LH

Hide 85353 3.REMOVE HEADLIGHT WASHER COVER RH

HINT:

Use the same procedure as for the LH side.


Hide 85208A 4.REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY LH

a.
E377630C01
0,0 0,0 false
V100135

Push
V113147

Disconnect in this Direction


Disengage the claw and disconnect the headlight cleaner hose as shown in the illustration.


b.
E377621C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the headlight cleaner clamp as shown in the illustration.


c.

Slide the collar as shown in the illustration.

E377623


d.

Disengage the claw and guide as indicated by the arrows, in the order shown in the illustration to remove the headlight washer actuator sub-assembly LH.

E377625C01
0,0 0,0 false
V100135

Push
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2) - -



Hide 85207A 5.REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.