Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER CONTROL RELAY › 2018.04–2021.02
RM33A0E _59 Vehicle Exterior _065394 WIPER / WASHER _0321234 HEADLIGHT CLEANER CONTROL RELAY A

WIPER / WASHER  HEADLIGHT CLEANER CONTROL RELAY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during headlight cleaner control relay removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link
Front bumper assembly (w/ Panoramic View Monitor System) Front television camera view adjustment Panoramic View Monitor System (Click here)

PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

Hide 85942 2.REMOVE HEADLIGHT CLEANER CONTROL RELAY

a.
E379217C01
0,0 0,0 false
V113147

Remove in this Direction


Disconnect the connector.


b.

Disengage the claw and remove the headlight cleaner control relay as shown in the illustration.