Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER MOTOR › 2018.04–2021.02
RM33A0E _59 Vehicle Exterior _065394 WIPER / WASHER _0321233 HEADLIGHT CLEANER MOTOR A

WIPER / WASHER  HEADLIGHT CLEANER MOTOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during headlight cleaner motor and pump assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link
Front bumper assembly (w/ Panoramic View Monitor System) Front television camera view adjustment Panoramic View Monitor System (Click here)

PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

Hide 85280A 2.REMOVE HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY

a.
E373550C01
0,0 0,0 false
V113147

Remove in this Direction


Loosen the clip and remove the headlight cleaner hose as shown in the illustration.


b.
E373552C01
0,0 0,0 false
V113147

Remove in this Direction


Disconnect the connector.


c.

Remove the headlight cleaner motor and pump assembly as shown in the illustration.