Home › Vehicle Interior › HEATING / AIR CONDITIONING › AMBIENT TEMPERATURE SENSOR › 2018.04–2021.02
RM33A0E _58 Vehicle Interior _065387 HEATING / AIR CONDITIONING _0319113 AMBIENT TEMPERATURE SENSOR A

HEATING / AIR CONDITIONING  AMBIENT TEMPERATURE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during thermistor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly (w/ Panoramic View Monitor System) Front television camera view adjustment Panoramic view monitor system (Click here)

PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

Hide 16691A 2.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE RH

a.

w/o Air Cooled Transmission Oil Cooler:

i.
E363451

Disengage the 2 claws to remove the front radiator side air guide plate RH.



b.

w/ Air Cooled Transmission Oil Cooler:

i.
E387127

Disengage the 2 claws to remove the front radiator side air guide plate RH.



Hide 88790B 3.REMOVE THERMISTOR ASSEMBLY

a.

w/o Air Cooled Transmission Oil Cooler:

i.
E363452

Disengage the clamp.


ii.

Disconnect the connector to remove the thermistor assembly.



b.

w/ Air Cooled Transmission Oil Cooler:

i.
E387128

Disengage the clamp.


ii.

Disconnect the connector to remove the thermistor assembly.