Home › Power Source / Network › NETWORKING › ACCESSORY GATEWAY ECU › from 2021.02
RM33A0E _57 Power Source / Network _065377 NETWORKING _0344089 ACCESSORY GATEWAY ECU A

NETWORKING  ACCESSORY GATEWAY ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during accessory gateway ECU (network gateway ECU) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Tracing Assist System (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic View Monitor System (Click here)

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 67914 3.REMOVE FRONT DOOR SCUFF PLATE LH

Hide 62112A 4.REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH

Hide 62312B 5.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH

Hide 55318C 6.REMOVE INSTRUMENT SIDE PANEL LH

Hide 55606 7.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55436B 8.REMOVE NO. 2 METER HOOD CLUSTER

Hide 53601 9.DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Hide 55302D 10.REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY

Hide 55435B 11.REMOVE NO. 1 METER HOOD CLUSTER

Hide 55434B 12.REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL

Hide 55308B 13.REMOVE NO. 3 INSTRUMENT PANEL TO COWL BRACE SUB-ASSEMBLY

Hide 89111 14.REMOVE ACCESSORY GATEWAY ECU (NETWORK GATEWAY ECU)

a.
C391384

Disconnect the accessory gateway ECU (network gateway ECU) connector.


b.

Disengage the clamp.


c.
C391385

Remove the nut and accessory gateway ECU (network gateway ECU).