Home › Drivetrain › UB80E (AUTOMATIC TRANSMISSION / TRANSAXLE) › AIR COOLED OIL COOLER › from 2021.02
RM33A0E _52 Drivetrain _065352 UB80E AUTOMATIC TRANSMISSION / TRANSAXLE _0461249 AIR COOLED OIL COOLER A

UB80E AUTOMATIC TRANSMISSION / TRANSAXLE  AIR COOLED OIL COOLER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during oil cooler assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly
·

Measure ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking Support Brake System (Click here)
Front television camera view adjustment Panoramic View Monitor System (Click here)

PROCEDURE

Hide 53851M 1.REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

Hide 53852K 2.REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

Hide 51441 3.REMOVE NO. 1 ENGINE UNDER COVER

Hide 4.REMOVE FRONT BUMPER ASSEMBLY

Hide 52618 5.REMOVE FRONT LOWER BUMPER ABSORBER

Hide 52611 6.REMOVE FRONT BUMPER ENERGY ABSORBER

Hide 52131A 7.REMOVE FRONT BUMPER REINFORCEMENT

Hide 16695A 8.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE LH

a.
C454116

Disengage the 2 clips to remove the front radiator side air guide plate LH.


Hide 9.DISCONNECT OIL COOLER HOSE

a.
C378144

Slide the 2 clips and disconnect the 2 oil cooler hoses from the oil cooler assembly.

NOTICE:

Use a container to catch any fluid which flows out of the oil cooler hose and oil cooler assembly.



Hide 32910 10.REMOVE OIL COOLER ASSEMBLY

a.
C378146

Remove the 4 bolts and oil cooler assembly.

NOTICE:

Use a container to catch any fluid which flows out of the oil cooler assembly.