Home › Drivetrain › K120 (CVT) › OIL COOLER › from 2021.02
RM33A0E _52 Drivetrain _098634 K120 CVT _0461780 OIL COOLER A

K120 CVT  OIL COOLER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission oil cooler removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Replacement of CVT fluid ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly (Click here)

PROCEDURE

Hide 53852K 1.REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

Hide 53851M 2.REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

Hide 51441 3.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY

Hide 53737B 4.REMOVE FRONT FENDER APRON SEAL LH

Hide 16264D 5.REMOVE FLOW SHUTTING VALVE (NO. 2 WATER BY-PASS HOSE)

Hide 6.DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID

Hide 7.DISCONNECT OIL COOLER HOSE

Hide 16261G 8.DISCONNECT NO. 1 WATER BY-PASS HOSE

a.
C413799

Slide the clip and disconnect the No. 1 water by-pass hose from the transmission oil cooler.


Hide 33493A 9.REMOVE TRANSMISSION OIL COOLER

a.
C413800

Remove the 2 bolts and transmission oil cooler from the rear transaxle case sub-assembly.