Home › Drivetrain › K120 (CVT) › OIL COOLER › from 2021.02
RM33A0E _52 Drivetrain _098634 K120 CVT _0461780 OIL COOLER A

K120 CVT  OIL COOLER  INSTALLATION  


PROCEDURE

Hide 33493A 1.INSTALL TRANSMISSION OIL COOLER

a.

Install the transmission oil cooler to the rear transaxle case sub-assembly with the 2 bolts.

Torque:
13.5 N*m (138 kgf*cm, 10 ft.*lbf)


Hide 16261G 2.CONNECT NO. 1 WATER BY-PASS HOSE

a.
C413801C01
0.656,1.24 0.365,1.292 0.365,1.292 0.646,1.156 true 0.198,1.198 0.51,1.354 0.313,0.156 10 false *a 1.146,0.865 1.458,1.021 0.313,0.156 10 false *b 0.615,2.031 0.927,2.188 0.313,0.156 10 false *c 1,2.375 1.313,2.531 0.313,0.156 10 false *d 0.604,1.813 0.917,1.969 0.313,0.156 10 false *e
*a Paint Mark
*b 2 to 7 mm (0.0787 to 0.276 in.)
*c Upper
*d Front
*e 120° (Claw of Clip Location)


Connect the No. 1 water by-pass hose to the transmission oil cooler and slide the clip to secure it.

NOTICE:
·

Make sure to slide the No. 1 water by-pass hose until it contacts the hose stopper of the transmission oil cooler.

·

Make sure to align the paint mark of the No. 1 water by-pass hose with the paint mark of the transmission oil cooler.

·

Make sure that the claws of the clip are within the location shown in the illustration.




Hide 3.CONNECT OIL COOLER HOSE

Hide 16264D 4.INSTALL FLOW SHUTTING VALVE (NO. 2 WATER BY-PASS HOSE)

Hide 5.ADJUST CONTINUOUSLY VARIABLE TRANSAXLE FLUID

Hide 7.INSPECT FOR FLUID LEAKS

Hide 53737B 8.INSTALL FRONT FENDER APRON SEAL LH

Hide 51441 9.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY

Hide 53852K 10.INSTALL FRONT WHEEL OPENING EXTENSION PAD LH

Hide 53851M 11.INSTALL FRONT WHEEL OPENING EXTENSION PAD RH