Home › Drivetrain › K120 (CVT) › SHIFT STROKE SENSOR › from 2021.02
RM33A0E _52 Drivetrain _098634 K120 CVT _0461786 SHIFT STROKE SENSOR A

K120 CVT  SHIFT STROKE SENSOR  INSTALLATION  


PROCEDURE

Hide 89419B 1.INSTALL SHIFT STROKE SENSOR

a.
C395499

Coat the O-ring of the shift stroke sensor with Toyota Genuine CVT fluid FE.

NOTICE:

If reusing the shift stroke sensor, check that the O-ring is not damaged.



b.

Install the shift stroke sensor to the transaxle case sub-assembly with the bolt.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTICE:

Be careful not to damage the O-ring.



c.

Connect the shift stroke sensor connector.


Hide 17750A 2.INSTALL INLET AIR CLEANER ASSEMBLY

Hide 53295E 3.INSTALL COOL AIR INTAKE DUCT SEAL

Hide 4.INSPECT FOR FLUID LEAKS