Home › Steering › STEERING COLUMN › TILT AND TELESCOPIC MANUAL SWITCH › from 2021.02
RM33A0E _55 Steering _065371 STEERING COLUMN _0327419 TILT AND TELESCOPIC MANUAL SWITCH A

STEERING COLUMN  TILT AND TELESCOPIC MANUAL SWITCH  INSTALLATION  


PROCEDURE

Hide 89235A 1.INSTALL TILT AND TELESCOPIC SWITCH

a.

Engage the claw to install the tilt and telescopic switch.


b.

Connect the tilt and telescopic connector to the tilt and telescopic switch.


c.

Connect the spiral cable connector to the spiral cable sub-assembly.


Hide 45024 2.INSTALL LOWER STEERING COLUMN COVER SUB-ASSEMBLY

Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

for A25A-FKS: Click hereGeneral>MAINTENANCE>A25A-FKS BATTERY>INSTALLATION

for 2GR-FKS: Click hereGeneral>MAINTENANCE>2GR-FKS BATTERY>INSTALLATION

for M20A-FKS: Click hereGeneral>MAINTENANCE>M20A-FKS BATTERY>INSTALLATION

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 5. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM

Hide 6.PERFORM INITIALIZATION

Parking Assist Monitor System for Initialization:(Click here)
for Calibration:(Click here)
Panoramic View Monitor System for Initialization:(Click here)
for Calibration:(Click here)