Home › Engine / Hybrid System › CRUISE CONTROL › MILLIMETER WAVE RADAR SENSOR › from 2021.02
RM33A0E _51 Engine / Hybrid System _065357 CRUISE CONTROL _0328547 MILLIMETER WAVE RADAR SENSOR A

CRUISE CONTROL  MILLIMETER WAVE RADAR SENSOR  INSTALLATION  


PROCEDURE

Hide 88211B 1.INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY

NOTICE:

If the millimeter wave radar sensor assembly has been struck or dropped, replace the millimeter wave radar sensor assembly with a new one.


a.
E453594C02
2.906,0.802 3.042,1 0.135,0.198 10 true 1 0.49,0.823 0.635,1.01 0.146,0.188 10 true 2 1.698,0.135 1.844,0.313 0.146,0.177 10 true 3
V100135

Bolt
V100136

Screw


Engage the 2 guides.


b.

Install the millimeter wave radar sensor assembly with the 2 bolts and screw.

Torque:
Bolt : 2.5 N*m (25 kgf*cm, 22 in.*lbf)

NOTICE:

Do not overtighten the screw. The radiator grille sub-assembly may be damaged.


HINT:

Tighten the bolts and screw in the order shown in the illustration.



c.

Connect the connector.


Hide 53295E 2.INSTALL COOL AIR INTAKE DUCT SEAL

Hide 3.ADJUST MILLIMETER WAVE RADAR SENSOR

a.

When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.

HINT:

Millimeter wave radar sensor assembly learning can be performed by using either Target Adjustment (Triangle Target) or Target Adjustment (Flat Surface Target) or Driving Adjustment.

Target Adjustment (Triangle Target): Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>TARGET ADJUSTMENT(TRIANGLE TARGET)

Target Adjustment (Flat Surface Target): Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>TARGET ADJUSTMENT(FLAT SURFACE TARGET)

Driving Adjustment: Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>DRIVING ADJUSTMENT