When an impact is detected, a relay inside the door control battery is operated to switch the power source of the door lock with motor assemblies from the vehicle battery to the door control battery.
Inspect the fuses for circuits related to this system before performing the following procedure.
Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.
Before performing the inspection, check that DTC B1243 is not output.
Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>DTC CHECK / CLEAR
Check door lock operation.
Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>OPERATION CHECK
All doors lock and unlock normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the K162 door control battery connector.
Disconnect the K52 main body ECU (multiplex network body ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K162-9 (ACTG) - K52-9 (ACTG) | Always | Below 1 Ω |
| K162-9 (ACTG) or K52-9 (ACTG) - Other terminals and body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the 3B instrument panel junction block assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K162-4 (IG) - 3B-30 | Always | Below 1 Ω |
| K162-4 (IG) or 3B-30 - Other terminals and body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Reconnect the 3B instrument panel junction block assembly connector.
| *a | Component with harness connected
(Instrument Panel Junction Block Assembly) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3B-30 - Body ground | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the door control battery.
Click hereVehicle Interior>DOOR LOCK>DOOR CONTROL BATTERY>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Check door control battery operation.
Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>ON-VEHICLE INSPECTION
Collision detection door lock function operates normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG