This DTC is stored if the television camera controller and rear television camera assembly judges as a result of its self check that the vehicle information received via CAN communication and the vehicle information stored in the television camera controller do not match.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| C168D | Vehicle Information Unmatched | Vehicle information unmatched | ·
Camera view adjustment (calibration) ·
Steering angle setting ·
Television camera controller |
Circumference Monitoring Camera Control Module |
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| C168D | Vehicle Information Unmatched | Vehicle information unmatched | ·
Back camera position setting ·
Steering angle setting ·
Rear Television camera assembly |
Rear Camera |
When "!" is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>INITIALIZATION
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION
Recheck for DTCs and check that no DTCs are output.
| Result | Proceed to |
|---|---|
| DTC C168D is output ("Parking Assist Camera") | A |
| DTC C168D is output ("Panoramic View Monitor") | B |
A
B
Perform the following procedure depending on the memory conditions to register the vehicle information into the rear television camera assembly.
Refer to rear television camera assembly optical axis adjustment (back camera position setting).
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION
Refer to steering angle setting.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Recheck for DTCs and check that no DTCs are output.
If DTC C168D is output, perform the procedure to register the vehicle information into the rear television camera assembly.
If DTC C168D is still output after performing the procedure to register the vehicle information into the rear television camera assembly 3 times, replace the rear television camera assembly.
| Result | Proceed to |
|---|---|
| DTC C168D is output | A |
| DTC C168D is not output | B |
A
B
Perform the following procedure depending on the memory conditions to register the vehicle information to the television camera controller.
Refer to camera view adjustment (calibration).
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION
Refer to steering angle setting.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Check for DTCs.
DTC C168D is not output.
If DTC C168D is output, perform the procedure to allow the television camera controller to store the vehicle information again.
If DTC C168D is still output after performing the procedure to make the television camera controller store the vehicle information 3 times, replace the television camera controller.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Read the Data List according to the display on the GTS.
Back Camera Availability Consistency
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Back Camera Availability Consistency | Status of ECU stored in rear television camera assembly | OK/NG | OK: Normal
NG: Rear television camera assembly or television camera controller is abnormal |
- |
| Tester Display |
|---|
| Back Camera Availability Consistency |
| Result | Proceed to |
|---|---|
| NG is displayed | A |
| OK is displayed | B |
A
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION
B