Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › from 2021.02
RM33A0E _58 Vehicle Interior _065381 METER / GAUGE / DISPLAY _0323396 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Engine Oil Pressure Switch Circuit  


DESCRIPTION

The combination meter assembly and engine oil pressure switch assembly are connected via direct line. The combination meter assembly determines the engine oil pressure based on the engine oil pressure switch ON/OFF signal.

HINT:
·

The combination meter assembly receives engine RPM data signal from the ECM via CAN communication in order to output warnings.

·

The combination meter assembly operates the following to output oil pressure warnings:

(a)

Engine oil pressure warning buzzer

(b)

Engine oil pressure warning message on multi-information display




WIRING DIAGRAM

E369059E02
2.302,1.448 2.76,1.646 0.458,0.198 10 false ECM 2.417,2.615 4.135,2.948 1.719,0.333 10 false Engine Oil Pressure Switch Assembly 0.552,3.438 2.25,3.656 1.698,0.219 10 false : CAN Communication Line 4.594,3.104 6.438,3.344 1.844,0.24 10 false Combination Meter Assembly 4.604,2.948 4.885,3.135 0.281,0.188 10 false K21 4.708,2.146 4.99,2.333 0.281,0.188 10 false 9 3.5,2.167 3.656,2.354 0.156,0.188 10 false 1 4.969,2.156 5.365,2.333 0.396,0.177 10 false S 5.656,1.802 6.021,1.99 0.365,0.188 10 false 12 V 2.406,2.448 2.74,2.635 0.333,0.188 10 false C87

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

·

The following troubleshooting procedure is based on the assumption that the SFI system is normal. Confirm that the SFI system is not malfunctioning before performing the following procedure.

Click hereEngine / Hybrid System>2GR-FKS (ENGINE CONTROL)>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING



PROCEDURE

1.INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY
a.

Inspect the engine oil pressure switch assembly.

Click hereEngine / Hybrid System>2GR-FKS (LUBRICATION)>OIL PRESSURE SWITCH>INSPECTION


Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (ENGINE OIL PRESSURE SWITCH ASSEMBLY - COMBINATION METER ASSEMBLY)

NG

REPLACE ENGINE OIL PRESSURE SWITCH ASSEMBLY

2.CHECK HARNESS AND CONNECTOR (ENGINE OIL PRESSURE SWITCH ASSEMBLY - COMBINATION METER ASSEMBLY)
a.

Disconnect the K21 combination meter assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
C87-1 - K21-9 (S) Always Below 1 Ω
C87-1 or K21-9 (S) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE COMBINATION METER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR