Home › Vehicle Exterior › LIGHTING (EXT) › SIDE TURN SIGNAL LIGHT ASSEMBLY › from 2021.02
RM33A0E _59 Vehicle Exterior _065395 LIGHTING (EXT) _0327003 SIDE TURN SIGNAL LIGHT ASSEMBLY A

LIGHTING (EXT)  SIDE TURN SIGNAL LIGHT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during side turn signal light assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*: Applies only for when removing and installing or replacing the rear television camera assembly.

·

Side television camera assembly LH

·

Side television camera assembly RH


Side television camera view adjustment Panoramic view monitor system (Click here)
Replacement or removal and installation of 2 or more parts:
·

Front television camera assembly, front bumper assembly or radiator grille

·

Rear television camera assembly

·

Side television camera assembly LH or outer rear view mirror assembly LH

·

Side television camera assembly RH or outer rear view mirror assembly RH


·

Television camera view adjustment

·

Rear television camera assembly optical axis (Back camera position setting)*



HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 2.REMOVE OUTER MIRROR COVER WITH OUTER MIRROR HOLE COVER (w/o Panoramic View Monitor System)

Hide 87945 3.REMOVE OUTER MIRROR COVER (w/o Panoramic View Monitor System)

Hide 87945 4.REMOVE OUTER MIRROR COVER (w/ Panoramic View Monitor System)

Hide 5.REMOVE OUTER MIRROR HOLE COVER WITH SIDE TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System)

Hide 81740 6.REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY

a.
E366661

Disengage the 2 claws.


b.
E366662

Disengage the 2 guides to separate the side turn signal light assembly.


c.
E366663

Disconnect the connector to remove the side turn signal light assembly.