Home › Vehicle Exterior › LIGHTING (EXT) › SWITCH HOUSING › from 2021.02
RM33A0E _59 Vehicle Exterior _065395 LIGHTING (EXT) _0327011 SWITCH HOUSING A

LIGHTING (EXT)  SWITCH HOUSING  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the steering wheel switch housing removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Removal/installation of the spiral cable with sensor sub-assembly
·

Steering angle neutral point (Initialize parking assist monitor system)

·

Steering angle setting


Parking assist monitor system for Initialization
(Click here)
for Calibration
(Click here)
Steering angle neutral point (Initialize panoramic view monitor system) Panoramic view monitor system for Initialization
(Click here)
for Calibration
(Click here)
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane tracing assist system (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)

CAUTION:
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

Hide 1.REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

Hide 89235A 2.REMOVE TILT AND TELESCOPIC SWITCH (for Power Tilt and Power Telescopic Steering Column)

Hide 84650 3.REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY

Hide 84329 4.REMOVE TURN SIGNAL SWITCH

Hide 84319 5.REMOVE STEERING WHEEL SWITCH HOUSING

a.
E365648

Using pliers, expand the clamp as shown in the illustration.


b.
E365649C01
1.354,0.781 1.198,0.385 true 0.99,0.281 1.302,0.479 0.313,0.198 10 true *a
*a Protective Tape
V113147

Remove in this Direction


While holding the clamp expanded, using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the steering wheel switch housing as shown in the illustration.