The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during lower No. 2 instrument panel airbag assembly removal/installation are shown below.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Click hereGeneral>MAINTENANCE>A25A-FKS BATTERY>REMOVAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
67913
3.REMOVE FRONT DOOR SCUFF PLATE RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
62111A
4.REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
62311B
5.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH
Disconnect the front door opening trim weatherstrip RH to the extent that allows the removal of the instrument side panel RH.
55317A
6.REMOVE INSTRUMENT SIDE PANEL RH
55607
7.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55435B
8.REMOVE NO. 1 METER HOOD CLUSTER
55012A
9.REMOVE NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY
55476C
10.REMOVE INSTRUMENT PANEL FINISH PLATE GARNISH
73990
11.REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
|
Deployment Side |
When storing the lower No. 2 instrument panel airbag assembly, keep the airbag deployment side facing upward.
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Remove the 3 bolts.
Disengage the 3 claws to separate the lower No. 2 instrument panel airbag assembly.
When separating the lower No. 2 instrument panel airbag assembly, do not pull the airbag wire harness.
| *a | Protective Tape |
| *b | Airbag Connector |
| *c | Airbag Connector Locking Button |
|
Release in this Direction |
Using a screwdriver with its tip wrapped with protective tape, release the airbag connector locking button.
Disconnect the airbag connector to remove the lower No. 2 instrument panel airbag assembly.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.