Home › Engine / Hybrid System › A25A-FKS (FUEL) › FUEL TANK (w/ Canister Pump Module) › from 2021.02
RM33A0E _51 Engine / Hybrid System _065343 A25A-FKS FUEL _0319401 FUEL TANK(w/ Canister Pump Module) A

A25A-FKS FUEL  FUEL TANK(w/ Canister Pump Module)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel tank assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Tracing Assist System (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Gas leak from exhaust system is repaired Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

CAUTION:
·
A360563

Never perform work on fuel system components near any possible ignition sources.

·

Vaporized fuel could ignite, resulting in a serious accident.

·
A360564

Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.

·

Sparks could cause vaporized fuel to ignite, resulting in a serious accident.

·
A344817

The fuel tank assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the fuel tank assembly may fall off the engine lifter.



PROCEDURE

Hide 77020A 1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

Hide 2.DRAIN FUEL

Hide 17420 3.REMOVE CENTER EXHAUST PIPE ASSEMBLY

Hide 58399D 4.REMOVE NO. 2 FLOOR UNDER COVER

Hide 58398F 5.REMOVE NO. 1 FLOOR UNDER COVER

Hide 77641A 6.REMOVE NO. 1 FUEL TANK PROTECTOR

a.
A401810C01
1.115,2.75 2.073,2.75 true 0.948,2.656 1.26,2.813 0.313,0.156 10 false *a
*a Needle Nose Pliers


Using needle nose pliers, remove the 4 clips and No. 1 fuel tank protector from the fuel tank assembly.


Hide 77209F 7.DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY

a.
A401813

Disconnect the fuel tank main tube sub-assembly from the fuel pipe.

Click hereEngine / Hybrid System>A25A-FKS (FUEL)>FUEL SYSTEM>PRECAUTION


Hide 8.DISCONNECT FUEL TANK BREATHER TUBE SUB-ASSEMBLY

a.
A401815

Disconnect the fuel tank breather tube sub-assembly from the fuel pipe.

Click hereEngine / Hybrid System>A25A-FKS (FUEL)>FUEL SYSTEM>PRECAUTION


Hide 77213E 9.DISCONNECT FUEL TANK TO FILLER PIPE HOSE

a.
A401816

Disconnect the fuel tank to filler pipe hose from the fuel tank assembly.

Click hereEngine / Hybrid System>A25A-FKS (FUEL)>FUEL SYSTEM>PRECAUTION


Hide 77100 10.REMOVE FUEL TANK ASSEMBLY

CAUTION:

The fuel tank assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the fuel tank assembly may fall off the engine lifter.


a.

w/ Fuel Outlet Valve Assembly:

i.
A401814

Disconnect the fuel cut off valve with tube assembly from the fuel outlet valve assembly.

Click hereEngine / Hybrid System>A25A-FKS (FUEL)>FUEL SYSTEM>PRECAUTION



b.

w/o Fuel Outlet Valve Assembly:

i.
A449826

Disconnect the fuel cut off valve with tube assembly from the canister (charcoal canister assembly).

Click hereEngine / Hybrid System>A25A-FKS (FUEL)>FUEL SYSTEM>PRECAUTION



c.
A401817

Support the fuel tank assembly using an engine lifter.

HINT:

Using height adjustment attachments and plate lift attachments, keep the fuel tank assembly horizontal.



d.
A401818

Remove the 4 bolts, No. 1 fuel tank band sub-assembly LH and No. 1 fuel tank band sub-assembly RH.


e.

Lower the engine lifter to remove the fuel tank assembly.

NOTICE:
·

Be careful not to drop the fuel tank assembly.

·

When removing the fuel tank assembly, tilt it slightly to prevent it from interfering with the surrounding parts.




Hide 77209F 11.REMOVE FUEL TANK MAIN TUBE SUB-ASSEMBLY

a.
A401819

Disengage the clamp to remove the fuel tank main tube sub-assembly from the fuel tank assembly.


Hide 77656B 12.REMOVE NO. 6 FUEL TANK CUSHION

a.
A401820

Remove the No. 6 fuel tank cushion from the fuel tank assembly.


Hide 77652A 13.REMOVE NO. 2 FUEL TANK CUSHION

a.
A401821

Remove the 2 No. 2 fuel tank cushions from the fuel tank assembly.