Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR (for Rear Door) › from 2021.02
RM33A0E _59 Vehicle Exterior _065390 WINDOW / GLASS _0327254 POWER WINDOW REGULATOR MOTOR(for Rear Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Rear Door)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during power window regulator motor assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane Tracing Assist System (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
·

Door window regulator assembly

·

Power window regulator motor assembly

·

Door glass

·

Door glass run


Initialize power window control system
·

Auto up and down function

·

Jam protection function

·

Remote control function

·

Key-linked function

·

Wireless transmitter-linked function

·

Key-off operation function

·

Catch protection function

·

Window open warning function


(Click here)

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 74038B 3.REMOVE REAR DOOR ARMREST COVER SUB-ASSEMBLY

Hide 4.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL

Hide 74260 5.REMOVE REAR ARMREST ASSEMBLY

Hide 67604 6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 68174A 7.REMOVE REAR DOOR INNER GLASS WEATHERSTRIP

Hide 67844A 8.REMOVE REAR DOOR NO. 2 SERVICE HOLE COVER

Hide 67842E 9.REMOVE REAR DOOR SERVICE HOLE COVER

Hide 67848A 10.REMOVE REAR DOOR NO. 1 VENT SEAL

Hide 67858B 11.REMOVE REAR DOOR PANEL PROTECTOR

Hide 68152C 12.REMOVE REAR DOOR GLASS RUN

Hide 67872 13.DISCONNECT REAR DOOR WEATHERSTRIP

Hide 67408F 14.REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY

Hide 68124B 15.REMOVE REAR DOOR QUARTER WINDOW GLASS

Hide 68104 16.REMOVE REAR DOOR GLASS SUB-ASSEMBLY

Hide 17.REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY

Hide 85720E 18.REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY

a.
B469541

Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly.