Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for LHD)
RM33C0E _54 Brake _065443 BRAKE SYSTEM (OTHER) _0319349 BRAKE PEDAL(for LHD) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for LHD)  INSTALLATION  


PROCEDURE

Hide 47121 1.INSTALL BRAKE PEDAL PAD

a.

Install the brake pedal pad to the brake pedal support assembly.


Hide 84345 2.INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER

a.

Engage the 2 claws to install the stop light switch mounting adjuster.


Hide 47101A 3.INSTALL BRAKE PEDAL RETURN SPRING

a.
C376581

Install the brake pedal return spring to the brake pedal support assembly.

NOTICE:

Attach the bottom part of the brake pedal return spring first, making sure that the open part of the hook is facing the front of the vehicle. Attach the top part of the brake pedal return spring second, making sure that the open part of the hook is facing the rear of the vehicle.



Hide 4.INSTALL BRAKE PEDAL SUPPORT ASSEMBLY

a.

Install the brake pedal support assembly while avoiding the stud bolts of the brake booster support base.

NOTICE:

Be careful not to deform the bracket of the instrument panel reinforcement assembly.



b.
C376580

Install 2 new clips.


c.

Install the brake pedal support assembly to the instrument panel reinforcement assembly with the bolt.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)


d.

Engage the clamp to install the wire harness to the brake pedal support assembly.


Hide 44785D 5.INSTALL BRAKE MASTER CYLINDER GASKET

Hide 47210L 6.INSTALL BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY

Hide 47264A 7.INSTALL PUSH ROD PIN

Hide 84340 8.INSTALL STOP LIGHT SWITCH ASSEMBLY

Hide 89510D 9.INSTALL BRAKE PEDAL STROKE SENSOR ASSEMBLY

Hide 44571A 11.CONNECT NO. 1 BRAKE ACTUATOR HOSE

Hide 82111 12.CONNECT ENGINE ROOM MAIN WIRE

Hide 44551C 13.BLEED NO. 1 BRAKE ACTUATOR TUBE

Hide 14.CONNECT BRAKE BOOSTER PUMP CONNECTOR

Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for LHD)>INSTALLATION

HINT:

Perform this operation only when the accumulator pressure zero down operation could not be performed using the GTS.


Hide 15.FILL RESERVOIR WITH BRAKE FLUID

Hide 16.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 17.BLEED BRAKE SYSTEM

Hide 18.INSPECT AND ADJUST BRAKE PEDAL

Hide 55606 19.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 53607A 20.INSTALL FRONT CENTER UPPER SUSPENSION BRACE SUB-ASSEMBLY

Hide 55708 21.INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY