Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for RHD)
RM33C0E _54 Brake _065443 BRAKE SYSTEM (OTHER) _0319350 BRAKE PEDAL(for RHD) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for RHD)  INSTALLATION  


PROCEDURE

Hide 47121 1.INSTALL BRAKE PEDAL PAD

a.

Install the brake pedal pad to the brake pedal support assembly.


Hide 84345 2.INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER

a.

Engage the 2 claws to install the stop light switch mounting adjuster.


Hide 47101A 3.INSTALL BRAKE PEDAL RETURN SPRING

a.
C377990

Install the brake pedal return spring to the brake pedal support assembly.

NOTICE:

Attach the bottom part of the brake pedal return spring first, making sure that the open part of the hook is facing the front of the vehicle. Attach the top part of the brake pedal return spring second, making sure that the open part of the hook is facing the rear of the vehicle.



Hide 4.INSTALL BRAKE PEDAL SUPPORT ASSEMBLY

a.

Install the brake pedal support assembly while avoiding the stud bolts of the brake booster support base.

NOTICE:

Be careful not to deform the bracket of the instrument panel reinforcement assembly.



b.
C377989

Install 2 new clips.


c.

Install the brake pedal support assembly to the instrument panel reinforcement assembly with the bolt.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)


d.

Engage the clamp to install the wire harness to the brake pedal support assembly.


Hide 44785D 5.INSTALL BRAKE MASTER CYLINDER GASKET

Hide 47210L 6.INSTALL BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY

Hide 47264A 7.INSTALL PUSH ROD PIN

Hide 84340 8.INSTALL STOP LIGHT SWITCH ASSEMBLY

Hide 89510D 9.INSTALL BRAKE PEDAL STROKE SENSOR ASSEMBLY

Hide 44571A 12.CONNECT NO. 1 BRAKE ACTUATOR HOSE

Hide 82111 13.INSTALL ENGINE ROOM MAIN WIRE

Hide 44551C 14.BLEED NO. 1 BRAKE ACTUATOR TUBE

Hide 15.CONNECT BRAKE BOOSTER PUMP CONNECTOR

Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for RHD)>INSTALLATION

HINT:

Perform this operation only when the accumulator pressure zero down operation could not be performed using the GTS.


Hide 16.FILL RESERVOIR WITH BRAKE FLUID

Hide 17.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 18.BLEED BRAKE SYSTEM

Hide 19.INSPECT AND ADJUST BRAKE PEDAL

Hide 12601B 20.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 53607A 21.INSTALL FRONT CENTER UPPER SUSPENSION BRACE SUB-ASSEMBLY

Hide 55708 22.INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY