Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM
RM33C0E _54 Brake _065442 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0328411 ELECTRONICALLY CONTROLLED BRAKE SYSTEM J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  ABS does not Operate  


DESCRIPTION

When the electronically controlled brake system is operating, as the input piston and output piston are not directly connected, the kickback of the brake pedal is minimal during ABS operation and the driver may not notice that ABS operated.

CAUTION / NOTICE / HINT

NOTICE:

After replacing the skid control ECU (brake booster with master cylinder assembly), perform linear solenoid valve offset learning, ABS holding solenoid valve learning, yaw rate and acceleration sensor zero point calibration and system information memorization after performing "Reset Memory".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>INITIALIZATION


PROCEDURE

1.BRAKE PROBLEM CHECK
a.

Check if the slip indicator light was illuminated or blinking when ABS did not operate.

HINT:
·

When the VSC system is normal and ABS is operating, the slip indicator light blinks.

·

When the VSC system is malfunctioning, the slip indicator light illuminates.




Result:
Result Proceed to
The slip indicator light was blinking. A
The slip indicator light was illuminated. B



A

END

B

2.CHECK DTC AND FREEZE FRAME DATA
2.CHECK DTC AND FREEZE FRAME DATA
a.

Using the GTS, check DTCs and Freeze Frame Data.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105

Result:
Result Proceed to
DTCs are not output. A
DTCs are output. B



A

3.PERFORM OPERATION CHECK DRIVING

B

3.PERFORM OPERATION CHECK DRIVING
a.

Check that ABS operates using a drum tester or equivalent.

CAUTION:

When using a drum tester, enter Inspection Mode or VSC off mode and perform inspection with the TRC and VSC systems disabled to prevent the vehicle from moving suddenly due to TRC or VSC operation.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE


OK:

ABS operates.



Result:
Proceed to
OK
NG



OK

END

NG

REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY