Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM
RM33C0E _54 Brake _065442 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0328411 ELECTRONICALLY CONTROLLED BRAKE SYSTEM J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  VSC does not Operate or VSC does not Operate Correctly  


DESCRIPTION

When ABS, TRC or VSC is operating, the skid control ECU (brake booster with master cylinder assembly) blinks the slip indicator light to inform the driver that slippage occurred.

When a communication malfunction with the hybrid vehicle control ECU assembly is detected, TRC and VSC are disabled. Also, TRC and VSC are disabled when a DTC is stored.

PROCEDURE

1.BRAKE PROBLEM CHECK
a.

Check whether the slip indicator light was illuminated when VSC did not operate.

OK:

The slip indicator light was illuminated.


HINT:

When a DTC is stored, the slip indicator light is illuminated and VSC does not operate due to the fail-safe function.



b.

Check whether the vehicle speed was 15 km/h (9 mph) or less when VSC did not operate.

OK:

The vehicle speed was 15 km/h (9 mph) or less.


HINT:

VSC does not operate when the vehicle speed is 15 km/h (9 mph) or less.



c.

Check whether the vehicle was driven straight for a few seconds at 35 km/h (22 mph) or more.

OK:

The vehicle was not driven straight for a few seconds at 35 km/h (22 mph) or more.


HINT:

When the power switch is turned on (IG), as steering angle sensor zero point calibration is not performed below 35 km/h (22 mph), VSC will not operate until the vehicle is driven straight for a few seconds at 35 km/h (22 mph) or more.



Result:
Proceed to
OK
NG



OK

END

NG

2.CHECK DTC
2.CHECK DTC
a.

Clear the DTCs.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Clear DTCs
50002 105

b.

Turn the power switch off.


c.

Turn the power switch on (IG).


d.

Check the DTCs (electronically controlled brake system) that are output.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105

Result:
Result Proceed to
DTCs are not output. A
Electronically controlled brake system DTCs are output. B



A

3.CHECK TIRES

B

3.CHECK TIRES
a.

Check that the tire of each wheel is the correct size.

Click hereSuspension>TIRE / WHEEL>TIRE AND WHEEL SYSTEM>INSPECTION

OK:

The tire of each wheel is the correct size.



Result:
Proceed to
OK
NG



OK

4.CHECK AIRBAG SENSOR ASSEMBLY INSTALLATION

NG

REPLACE THE TIRE OF EACH WHEEL WITH THE CORRECT SIZE

4.CHECK AIRBAG SENSOR ASSEMBLY INSTALLATION
a.

Turn the power switch off.


b.

Check that the yaw rate and acceleration sensor (airbag sensor assembly) has been installed properly.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>INSTALLATION

OK:

The yaw rate and acceleration sensor (airbag sensor assembly) is tightened to the specified torque.

The yaw rate and acceleration sensor (airbag sensor assembly) is not tilted.



Result:
Proceed to
OK
NG



OK

NG