Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM
RM33C0E _54 Brake _065442 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0328411 ELECTRONICALLY CONTROLLED BRAKE SYSTEM J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  Excessive Brake Pedal Travel (No Fluid Leaks and No Air in System)  


DESCRIPTION

Depending on the malfunction, the skid control ECU (brake booster with master cylinder assembly) prohibits operation of the electronically controlled brake system to protect components and prevent incorrect operation when DTCs are stored.

If the switching solenoid is disabled due to prohibition of the electronically controlled brake system, the response of the brake pedal changes and braking performance is reduced.

CAUTION / NOTICE / HINT

NOTICE:

After replacing the skid control ECU (brake booster with master cylinder assembly), perform linear solenoid valve offset learning, ABS holding solenoid valve learning, yaw rate and acceleration sensor zero point calibration and system information memorization after performing "Reset Memory".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>INITIALIZATION


PROCEDURE

1.BRAKE PROBLEM CHECK
a.

Check the conditions at the time the problem occurred.

i.

Whether a warning light illuminated or the buzzer sounded.


ii.

Road surface condition when the problem occurred and just before the problem occurred.


iii.

When the problem occurred and how many times the brake pedal was depressed before the problem occurred.


iv.

Frequency of the abnormal brake pedal response.



Result:
Proceed to
NEXT



NEXT

2.CHECK DTC AND FREEZE FRAME DATA
2.CHECK DTC AND FREEZE FRAME DATA
a.

Using the GTS, check DTCs and Freeze Frame Data.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105
Result:
Result Proceed to
DTCs are not output. A
DTCs are output. B


HINT:
·

If there are currently no warnings and the brake pedal travel is not excessive, DTCs may have been cleared after the system returned to normal.

·

If the brake pedal response returned to normal and there are currently no warnings, the system is normal.





A

3.CHECK BRAKE PEDAL

B

3.CHECK BRAKE PEDAL
a.

While depressing the brake pedal by hand, check the installation condition of the brake pedal stroke sensor assembly and brake pedal, and check for mechanical malfunctions.


b.

Check and adjust the brake pedal height.

for LHD: Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL (for LHD)>ADJUSTMENT

for RHD: Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL (for RHD)>ADJUSTMENT


Result:
Proceed to
NEXT



NEXT

4.INSPECT BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY
4.INSPECT BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY
a.

Check the brake booster with master cylinder assembly.

Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE SYSTEM>ON-VEHICLE INSPECTION

OK:

The brake booster with master cylinder assembly is normal.



Result:
Proceed to
OK
NG



OK

NG

REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY