This DTC is stored if the headlight ECU sub-assembly LH for another destination is installed.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| B2456 | Left Headlight ECU Variation Error | Detection condition:
The power switch is on (IG). Malfunction status:
Vehicle specification information received via CAN communication is continuously mismatched Malfunction duration:
- |
·
Hybrid vehicle control ECU assembly ·
Main body ECU (multiplex network body ECU) ·
Headlight ECU sub-assembly LH |
HL AutoLeveling |
If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.
Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.
Before replacing the hybrid vehicle control ECU assembly, refer to Service Bulletin.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.
Check for DTCs.
DTC B2456 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Check if the part number of the hybrid vehicle control ECU assembly installed to the vehicle is correct.
Part number is correct.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check if the part number of the main body ECU (multiplex network body ECU) installed to the vehicle is correct.
Part number is correct.
| Proceed to |
|---|
| OK |
| NG |
OK
NG