1.ADJUST COMPRESSOR OIL
When replacing the compressor with motor assembly with a new one, gradually discharge the inert gas from the service valve, and drain the following amount of oil from the new compressor with motor assembly before installation.
(Oil capacity inside the new compressor with motor assembly: 120 to 135 cc (4.06 to 4.56 fl. oz)) - (Remaining oil amount in the removed compressor with motor assembly) = (Oil amount to be removed from the new compressor)
If a new compressor with motor assembly is installed without removing some oil, there will be too much oil in the system due to the oil remaining in the pipes of the vehicle. Excessive oil in the system prevents heat exchange in the refrigeration cycle and causes ineffective cooling.
If the amount of oil remaining in the old compressor with motor assembly is too small, check the air conditioning system for oil leaks.
Be sure to use ND-OIL 11 or equivalent compressor oil. If any compressor oil other than ND-OIL 11 is used, compressor with motor assembly insulation performance may decrease, resulting in leakage of electric power.
88370
2.INSTALL COMPRESSOR WITH MOTOR ASSEMBLY
Using an E8 "TORX" socket wrench, temporarily install the compressor with motor assembly with the 2 stud bolts.
|
Bolt |
|
Nut |
Install the compressor with motor assembly with the bolt and 2 nuts.
Tighten the bolt and nuts in the order shown in the illustration.
| *a | Connector (A) |
| *b | Connector (B) |
| *c | Green-colored Lock |
|
Slide |
Connect the connector (B).
Remove the insulating tape from the connector (A).
Connect the connector (A) and slide the green-colored lock as shown in the illustration to securely lock it.
Make sure to wear insulated gloves.
Make sure that the connector is connected securely.
Connect the 2 connectors.
88711
3.CONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE SUB-ASSEMBLY
Remove the vinyl tape from the No. 1 cooler refrigerant discharge hose sub-assembly.
Sufficiently apply compressor oil to a new O-ring and the fitting surface of the compressor with motor assembly.
ND-OIL 11 or equivalent
Install the O-ring to the No. 1 cooler refrigerant discharge hose sub-assembly.
Keep the O-ring and O-ring fitting surface free of foreign matter.
Connect the No. 1 cooler refrigerant discharge hose sub-assembly to the compressor with motor assembly with the bolt.
88704
4.CONNECT SUCTION HOSE SUB-ASSEMBLY
Remove the vinyl tape from the suction hose sub-assembly.
Sufficiently apply compressor oil to a new O-ring and the fitting surface of the compressor with motor assembly.
ND-OIL 11 or equivalent
Install the O-ring to the suction hose sub-assembly.
Keep the O-ring and O-ring fitting surface free of foreign matter.
Connect the suction hose sub-assembly to the compressor with motor assembly with the bolt.
17750A
5.INSTALL INLET AIR CLEANER ASSEMBLY
53295E
6.INSTALL COOL AIR INTAKE DUCT SEAL
G3834
7.INSTALL SERVICE PLUG GRIP
8.CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT
9.WARM UP COMPRESSOR
10.INSPECT FOR REFRIGERANT LEAK