When the windshield washer motor and pump assembly receives signals from the windshield wiper switch assembly it operates to spray washer fluid from the washer nozzle sub-assemblies.
Inspect the fuses of circuits related to this system before performing the following procedure.
Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter following menus: Body Electrical / Main Body / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Front Washer Relay | Function to operate the windshield washer motor and pump assembly | OFF or ON | - |
| Tester Display |
|---|
| Front Washer Relay |
Windshield washer motor and pump assembly operates normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the windshield washer motor and pump assembly.
Click hereVehicle Exterior>WIPER / WASHER>WASHER MOTOR>REMOVAL
Inspect the windshield washer motor and pump assembly.
Click hereVehicle Exterior>WIPER / WASHER>WASHER MOTOR>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect the WASHER relay.
Click hereVehicle Exterior>WIPER / WASHER>RELAY>ON-VEHICLE INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (WASHER relay) - Body ground | Power switch off | Below 1 V |
| Power switch on (IG) | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A32-1 - Body ground | Power switch off | Below 1 V |
| Power switch on (IG) | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 5 (WASHER relay) - A32-2 | Always | Below 1 Ω |
| 5 (WASHER relay) or A32-2 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 (WASHER relay) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the K51 main body ECU (multiplex network body ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K51-12 (FWSR) - 2 (WASHER relay) | Always | Below 1 Ω |
| K51-12 (FWSR) or 2 (WASHER relay) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG