Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The following procedure is for LHD vehicles.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
89710C
1.REMOVE POSITION CONTROL ECU ASSEMBLY RH (w/ Seat Position Memory System)
73240
2.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)
73230
3.REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)
71074S
4.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER
Disconnect the rubber band of the separate type front seatback cover.
71868N
5.REMOVE FRONT SEAT FRONT CUSHION SHIELD
Remove the clip.
|
Remove in this Direction |
Disengage the guide as shown in the illustration.
|
Remove in this Direction |
Disengage the 2 claws as shown in the illustration.
Disengage the 3 guides to remove the front seat front cushion shield.
71812D
6.REMOVE FRONT SEAT CUSHION SHIELD (w/o Vertical Adjuster)
Disengage the 3 claws.
Disengage the claw and 2 guides.
| *a | Protective Tape |
|
Remove in this Direction |
Using a screwdriver with its tip wrapped with protective tape, disengage the claw and slightly pull the front seat cushion shield as shown in the illustration.
|
Remove in this Direction |
Disengage the guide as shown in the illustration.
Disconnect the front power seat switch connector to remove the front seat cushion shield.
71862
7.REMOVE FRONT SEAT INNER CUSHION SHIELD (w/o Vertical Adjuster)
Disengage the 3 claws.
|
Remove in this Direction |
Disengage the 2 claws and 2 guides to remove the front seat inner cushion shield as shown in the illustration.
71812D
8.REMOVE FRONT SEAT CUSHION SHIELD (w/ Vertical Adjuster)
Disengage the 2 claws.
Disengage the claw and 2 guides.
| *a | Protective Tape |
|
Remove in this Direction |
Using a screwdriver with its tip wrapped with protective tape, disengage the claw and slightly pull the front seat cushion shield as shown in the illustration.
|
Remove in this Direction |
Disengage the guide as shown in the illustration.
Disconnect the front power seat switch connector to remove the front seat cushion shield.
71862
9.REMOVE FRONT SEAT INNER CUSHION SHIELD (w/ Vertical Adjuster)
Disengage the 2 claws.
|
Remove in this Direction |
Disengage the 2 claws and 2 guides to remove the front seat inner cushion shield as shown in the illustration.
84921B
10.REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
Using a moulding remover, disengage the 4 claws to remove the slide and vertical power seat switch knob.
84921A
11.REMOVE RECLINING POWER SEAT SWITCH KNOB
Using a moulding remover, disengage the 4 claws to remove the reclining power seat switch knob.
72714
12.REMOVE SEAT ADJUSTER SHIELD CLAMP BRACKET (w/ Vertical Adjuster)
Remove the 2 screws and seat adjuster shield clamp bracket from the front seat cushion shield.
84922C
13.REMOVE FRONT POWER SEAT SWITCH
72136B
14.REMOVE LOWER NO. 3 SEAT TRACK SPACER (for LH Side)
w/ Rear Seat Belt Warning System:
Disengage the claw and 2 guides to remove the lower No. 3 seat track spacer from the front seat cushion shield.
72136C
15.REMOVE LOWER NO. 4 SEAT TRACK SPACER (for LH Side)
w/ Rear Seat Belt Warning System:
Disengage the claw and 2 guides to remove the lower No. 4 seat track spacer from the front seat inner cushion shield.
72136A
16.REMOVE LOWER NO. 2 SEAT TRACK SPACER (for RH Side)
w/ Rear Seat Belt Warning System:
Use the same procedure as for the Lower No. 4 Seat Track Spacer (for LH Side).
72136
17.REMOVE LOWER NO. 1 SEAT TRACK SPACER (for RH Side)
w/ Rear Seat Belt Warning System:
Use the same procedure as for the Lower No. 3 Seat Track Spacer (for LH Side).
18.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
Disengage the 2 hooks.
w/o Vertical Adjuster:
Disengage the claw and 4 clamps to separate the front seat airbag assembly wire harness.
Disengage the 4 clamps first.
w/ Vertical Adjuster:
Disengage the claw and 4 clamps to separate the front seat airbag assembly wire harness.
Disengage the 4 clamps first.
Disconnect the connector.
Disengage the clamp.
w/ Seat Heater System:
Disengage the clamp.
Disconnect the front seatback heater assembly connector.
Remove the 4 bolts.
Disengage the 4 guides to remove the separate type front seatback assembly from the separate type front seat cushion assembly.
71931
19.REMOVE FRONT SEAT HEADREST SUPPORT
Disengage the 3 hooks.
w/ Seat Heater System:
Disengage the clamp.
Open the 2 fasteners.
w/o Rear Seat Belt Warning System:
|
Remove in this Direction |
Disengage the hook as shown in the illustration.
| *1 | Seatback Cover Hook |
| *a | Pin |
Pull up the pin of the seatback cover hook as shown in the illustration and remove the seatback cover hook.
| *1 | Seat Cover Hanger |
| *a | Bracket |
|
Remove in this Direction |
Slide the bracket as shown in the illustration to disengage the hook and disconnect the bracket from the seat cover hanger.
Disengage the 4 claws and remove the 2 front seat headrest supports.
20.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
Remove the separate type front seatback cover with pad.
71074S
21.REMOVE SEPARATE TYPE FRONT SEATBACK COVER
Using a screwdriver, disengage the 9 claws and remove the separate type front seatback cover from the separate type front seatback pad as shown in the illustration.
| *a | Screwdriver | - | - |
87510N
22.REMOVE FRONT SEATBACK HEATER ASSEMBLY (w/ Seat Heater System)
73920A
23.REMOVE FRONT SEAT AIRBAG ASSEMBLY
85867
24.REMOVE SEATBACK CLIMATE CONTROL BLOWER (w/ Climate Control Seat System)
| *a | Wire Harness Clamp |
| *b | Hook |
Disengage the wire harness clamp and disconnect the connector.
Disengage the 2 claws and 2 hooks and remove the seatback climate control blower.
72760D
25.REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY (w/ Vertical Adjuster)
71054S
26.REMOVE FRONT SEATBACK SPRING SUB-ASSEMBLY (w/o Vertical Adjuster)
Disengage the 2 claws to separate the 2 front seatback edge protectors from the front seatback frame sub-assembly.
|
Remove in this Direction |
Remove the front seatback spring sub-assembly from the front seatback frame sub-assembly as shown in the illustration.
71587
27.REMOVE FRONT SEATBACK EDGE PROTECTOR
w/o Vertical Adjuster:
Remove the 2 front seatback edge protectors from the front seatback spring sub-assembly.
w/ Vertical Adjuster:
Remove the 2 front seatback edge protectors from the lumbar support adjuster assembly.
71759D
28.REMOVE FRONT NO. 2 SEATBACK HOOK
Remove the 2 front No. 2 seatback hooks from the front seatback frame sub-assembly.
8219B
29.REMOVE FRONT SEAT NO. 2 WIRE
Disconnect each connector and disengage each clamp to remove the front seat No. 2 wire.
30.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
|
Remove in this Direction |
w/ Occupant Detection Sensor:
Disengage the claw to separate the connector holder as shown in the illustration.
|
Remove in this Direction |
Disengage the claw to remove the connector holder from the occupant detection sensor wire harness as shown in the illustration.
w/ Seat Heater System:
Disconnect the connector.
Disengage the clamp.
Disengage the 10 hooks and remove the separate type front seat cushion cover with pad from the separate type front seat cushion spring assembly.
71072S
31.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER
Using a screwdriver, disengage the 14 claws and remove the separate type front seat cushion cover from the separate type front seat cushion pad as shown in the illustration.
| *a | Screwdriver | - | - |
87510L
32.REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY (w/ Seat Heater System)
85860A
33.REMOVE SEAT CUSHION CLIMATE CONTROL BLOWER ASSEMBLY (w/ Climate Control Seat System)
w/ Vertical Adjuster:
Disengage the wire harness clamp.
Disconnect the connector.
Remove the 2 bolts.
Disengage the hook and remove the seat cushion climate control blower assembly.
71875G
34.REMOVE LH SEAT RECLINING ADJUSTER INSIDE COVER LH (w/ Vertical Adjuster)
Disengage the claw.
Disengage the 4 claws to remove the LH seat reclining adjuster inside cover LH.
71876G
35.REMOVE LH SEAT RECLINING ADJUSTER INSIDE COVER RH (w/ Vertical Adjuster)
Disengage the 4 claws to remove the LH seat reclining adjuster inside cover RH.
71876F
36.REMOVE RH SEAT RECLINING ADJUSTER INSIDE COVER LH (w/o Vertical Adjuster)
Disengage the 4 claws to remove the RH seat reclining adjuster inside cover LH.
71875F
37.REMOVE RH SEAT RECLINING ADJUSTER INSIDE COVER RH (w/o Vertical Adjuster)
Disengage the clamp and claw.
Disengage the 4 claws to remove the RH seat reclining adjuster inside cover RH.
71874A
38.REMOVE FRONT SEAT LOWER CUSHION SHIELD LH (w/ Vertical Adjuster)
| *a | Hook |
| *b | Guide |
Disengage the hook.
Disengage the claw and guide to remove the front seat lower cushion shield LH.
71873U
39.REMOVE FRONT SEAT LOWER CUSHION SHIELD RH (w/ Vertical Adjuster)
| *a | Hook |
| *b | Guide |
Disengage the hook.
Disengage the claw and guide to remove the front seat lower cushion shield RH.
87501B
40.REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY (w/ Seat Heater System)
82192
41.REMOVE FRONT SEAT WIRE
Disconnect each connector and disengage each clamp to remove the front seat wire.
72277A
42.REMOVE SEAT SLIDE POSITION SENSOR PROTECTOR (w/ Occupant Classification System)
Disengage the clamp and disconnect the connector.
| *a | Pin |
| *b | Engagement Point |
|
Disengage in this Direction |
|
Slide in this Direction |
Disengage the seat slide position sensor protector from the pin of the seat position airbag sensor as shown in the illustration.
Slide the seat slide position sensor protector as shown in the illustration to remove it.
82192A
43.REMOVE FRONT SEAT NO. 3 WIRE (w/ Occupant Classification System)
Disengage the claw to remove the front seat No. 3 wire.
71052A
44.REMOVE FRONT SEAT CUSHION SPRING SUB-ASSEMBLY
Disengage the 6 hooks to remove the front seat cushion spring sub-assembly from the front seat adjuster assembly.
7181B
45.REMOVE FRONT SEAT CUSHION WIRE HARNESS HOLDER (w/o Vertical Adjuster)
Remove the 2 screws.
Disengage the claw to remove the front seat cushion wire harness holder.
7181B
46.REMOVE FRONT SEAT CUSHION WIRE HARNESS HOLDER (w/ Vertical Adjuster)
Remove the 2 screws.
|
Remove in this Direction |
Disengage the 2 claws.
Disengage the guide to remove the front seat cushion wire harness holder as shown in the illustration.
71874C
47.REMOVE FRONT SEAT LOWER CUSHION SHIELD (w/ Vertical Adjuster)
Disengage the claw.
|
Remove in this Direction |
Disengage the guide to remove the front seat lower cushion shield as shown in the illustration.
85822C
48.REMOVE POWER SEAT LIFTER MOTOR ASSEMBLY (w/ Vertical Adjuster)
Remove the power seat lifter motor assembly.
Remove the 3 nuts and front seat adjuster plate.
Remove the vertical adjuster spacer.
Remove the front seat vertical housing sub-assembly.
85822B
49.REMOVE POWER SEAT TILT MOTOR ASSEMBLY (w/ Vertical Adjuster)
Remove the 3 bolts and power seat tilt motor assembly.
72108
50.REMOVE UPPER SEAT TRACK RAIL SUB-ASSEMBLY (w/o Vertical Adjuster)
72106B
51.REMOVE UPPER SEAT TRACK RAIL SUB-ASSEMBLY (w/ Vertical Adjuster)