Wear protective gloves. Sharp areas on the seat frame may injure your hands.
72640A
1.INSTALL REAR SEATBACK LOCK ASSEMBLY LH
Install the rear seatback lock assembly LH with the 2 nuts.
|
Install in this Direction (1) |
|
Install in this Direction (2) |
Engage the guide to connect the rear seatback lock assembly LH as shown in the illustration.
72630C
2.INSTALL REAR SEATBACK LOCK ASSEMBLY RH
Use the same procedure as for the LH side.
64271G
3.INSTALL ROOM PARTITION BOARD RH
Engage the 5 clips.
Install the room partition board RH with the 2 clips.
64272B
4.INSTALL ROOM PARTITION BOARD LH
Engage the 4 clips and 2 claws.
Install the room partition board LH with the clip.
64330
5.INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/o Rear Sunshade)
Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly.
Engage the 3 clips and 5 guides.
Install the package tray trim panel assembly with the 2 clips.
64330
6.INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Rear Sunshade)
73373F
7.INSTALL REAR SEAT SHOULDER BELT HOLE COVER
62472A
8.INSTALL INNER ROOF SIDE GARNISH LH
62471A
9.INSTALL INNER ROOF SIDE GARNISH RH
Use the same procedure as for the LH side.
73370E
10.CONNECT REAR SEAT OUTER BELT ASSEMBLY LH
73360D
11.CONNECT REAR SEAT OUTER BELT ASSEMBLY RH
Use the same procedure as for the LH side.
64727A
12.INSTALL LUGGAGE COMPARTMENT TRIM INNER PAD
Install the luggage compartment trim inner pad.
81006
13.INSTALL CENTER STOP LIGHT SET
14.INSTALL REAR SEAT ASSEMBLY
64770
15.INSTALL SPARE WHEEL COVER ASSEMBLY