Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › 2017.09–2021.02
RM33C0E _56 Audio / Visual / Telematics _065450 AUDIO / VIDEO _0333622 AUDIO AND VISUAL SYSTEM C

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  C1610  Camera ECU Malfunction  


DESCRIPTION

This DTC is stored when a malfunction occurs in the parking assist monitor system.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1610 Camera ECU Malfunction Malfunction occurs in the parking assist monitor system
·

Parking assist monitor system

·

Radio and display receiver assembly



CAUTION / NOTICE / HINT

NOTICE:
·

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>PRECAUTION

·

When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:

-

A communication malfunction DTC may be stored.

-

The radio and display receiver assembly may not operate normally.




PROCEDURE

1.CHECK DTC (PARKING ASSIST MONITOR SYSTEM)
a.

Clear the DTCs.

Chassis > Parking Assist Camera > Clear DTCs
50002 85

b.

Recheck for DTCs and check that no DTCs are output.

Chassis > Parking Assist Camera > Trouble Codes
50001 85
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

2.CHECK DTC (AUDIO AND VISUAL SYSTEM)

NG

2.CHECK DTC (AUDIO AND VISUAL SYSTEM)
a.

Clear the DTCs.

Body Electrical > Navigation System > Clear DTCs
50002 212

b.

Recheck for DTCs and check that no DTCs are output.

Body Electrical > Navigation System > Trouble Codes
50001 212
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

END

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY