Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR (for Rear Door)
RM33C0E _59 Vehicle Exterior _065467 WINDOW / GLASS _0333695 POWER WINDOW REGULATOR MOTOR(for Rear Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Rear Door)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 85720E 2.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY

NOTICE:

The regulator arm must be below the intermediate position when installing the power window regulator motor assembly.


a.

Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.

Torque:
5.39 N*m (55 kgf*cm, 48 in.*lbf)

HINT:

When replacing a power window regulator motor assembly, a new power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.



Hide 3.INSTALL REAR DOOR WINDOW REGULATOR ASSEMBLY

Hide 68104 4.INSTALL REAR DOOR GLASS SUB-ASSEMBLY

Hide 68124B 5.INSTALL REAR DOOR QUARTER WINDOW GLASS

Hide 67408F 6.INSTALL REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY

Hide 67872 7.CONNECT REAR DOOR WEATHERSTRIP

Hide 68152C 8.INSTALL REAR DOOR GLASS RUN

Hide 67858B 9.INSTALL REAR DOOR PANEL PROTECTOR

Hide 67848A 10.INSTALL REAR DOOR NO. 1 VENT SEAL

Hide 67842E 11.INSTALL REAR DOOR SERVICE HOLE COVER

Hide 67844A 12.INSTALL REAR DOOR NO. 2 SERVICE HOLE COVER

Hide 68174A 13.INSTALL REAR DOOR INNER GLASS WEATHERSTRIP

Hide 67604 14.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 74260 15.INSTALL REAR ARMREST ASSEMBLY

Hide 16.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL

Hide 74038B 17.INSTALL REAR DOOR ARMREST COVER SUB-ASSEMBLY

Hide 18.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 64718C 19.INSTALL LUGGAGE TRIM SERVICE HOLE COVER

Hide 20.INITIALIZE POWER WINDOW CONTROL SYSTEM