Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. REPAIR INSTRUCTION
75988C
2.INSTALL REAR DOOR OUTSIDE STRIPE
Refer to the illustration to position a new rear door outside stripe.
| *A | Rear Side | *B | Front Side |
| *C | LH Side | *D | RH Side |
| *1 | Rear Door Weatherstrip | - | - |
| *a | Rib of Rear Door Frame Garnish | *b | Edge of Curved Surface (A) |
| *c | Edge of Curved Surface (B) | *d | Cutout |
| *e | Straight | *f | Triangle |
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 5.0 mm (0.197 in.) | B | 3.0 mm (0.118 in.) |
| C | 1.5 mm (0.0591 in.) | D | 2.5 mm (0.0984 in.) |
| E | 2.5 mm (0.0984 in.) | F | 1.0 mm (0.0394 in.) |
Remove the release paper and install the rear door outside stripe.
Align the cutout on the rear door outside stripe with the edge of curved surface (A) on the door frame and install the rear door outside stripe.
75978H
3.INSTALL REAR DOOR LOWER OUTSIDE STRIPE
Refer to the illustration to position a new rear door lower outside stripe.
| *A | Upper Side | *B | LH Side |
| *C | RH Side | - | - |
| *1 | Rear Door Weatherstrip | - | - |
| *a | Rib of Rear Door Frame Garnish | *b | Edge of Curved Surface |
| *c | Straight | *d | Triangle |
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 3.0 mm (0.118 in.) | B | 6.3 mm (0.248 in.) |
| C | 1.2 mm (0.0472 in.) | D | 1.0 mm (0.0394 in.) |
| E | -1.0 to 1.0 mm (-0.0394 to 0.0394 in.) | F | 1.0 mm (0.0394 in.) |
Remove the release paper and install the rear door lower outside stripe.
65923E
4.INSTALL CURTAIN HOOK (w/ Rear Door Sunshade)
67674A
5.INSTALL REAR DOOR FRAME GARNISH
68104
6.INSTALL REAR DOOR GLASS SUB-ASSEMBLY
68124B
7.INSTALL REAR DOOR QUARTER WINDOW GLASS
67408F
8.INSTALL REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY
67872
9.CONNECT REAR DOOR WEATHERSTRIP
68152C
10.INSTALL REAR DOOR GLASS RUN
67858B
11.INSTALL REAR DOOR PANEL PROTECTOR
67848A
12.INSTALL REAR DOOR NO. 1 VENT SEAL
67842E
13.INSTALL REAR DOOR SERVICE HOLE COVER
67844A
14.INSTALL REAR DOOR NO. 2 SERVICE HOLE COVER
68174A
15.INSTALL REAR DOOR INNER GLASS WEATHERSTRIP
67604
16.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
74260
17.INSTALL REAR ARMREST ASSEMBLY
18.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL
74038B
19.INSTALL REAR DOOR ARMREST COVER SUB-ASSEMBLY
20.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
64718C
21.INSTALL LUGGAGE TRIM SERVICE HOLE COVER
22. INITIALIZE POWER WINDOW CONTROL SYSTEM
23.INSPECT POWER WINDOW OPERATION