1.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
53019F
2.REMOVE RADIATOR SHUTTER SUB-ASSEMBLY
3.REMOVE HEADLIGHT ASSEMBLY LH (for LED Type Turn Signal Light)
4.REMOVE HEADLIGHT ASSEMBLY RH (for LED Type Turn Signal Light)
Use the same procedure as for the LH side.
5.REMOVE HEADLIGHT ASSEMBLY LH (for Bulb Type Turn Signal Light)
6.REMOVE HEADLIGHT ASSEMBLY RH (for Bulb Type Turn Signal Light)
Use the same procedure as for the LH side.
52611
7.REMOVE FRONT BUMPER ENERGY ABSORBER
52131A
8.REMOVE FRONT BUMPER REINFORCEMENT
53253B
9.REMOVE UPPER RADIATOR MOUNTING BRACKET
17750A
10.REMOVE INLET AIR CLEANER ASSEMBLY
53510
11.REMOVE HOOD LOCK ASSEMBLY
16595B
12.REMOVE NO. 1 RADIATOR AIR GUIDE LH
|
Remove in this Direction |
Remove the clip.
Disengage the claw and guide, and remove the No. 1 radiator air guide LH as shown in the illustration.
16593B
13.REMOVE NO. 1 RADIATOR AIR GUIDE RH
|
Remove in this Direction |
Remove the clip.
Disengage the claw and guide, and remove the No. 1 radiator air guide RH as shown in the illustration.
88711
14.DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE SUB-ASSEMBLY
Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose sub-assembly from the cooler condenser assembly.
Remove the O-ring from the No. 1 cooler refrigerant discharge hose sub-assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
88710E
15.DISCONNECT AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY
While pressing the end of the air conditioning tube and accessory assembly into the end of the cooler condenser assembly, use pliers to squeeze together both sides of the piping clamp until it breaks apart.
| *1 | Air Conditioning Tube and Accessory Assembly | *2 | Cooler Condenser Assembly |
| *3 | Piping Clamp | - | - |
| *a | Press In | - | - |
If any foreign matter is adhered to the connecting part, brush it off or use compressed air to remove it.
Make sure that fragments of the piping clamp do not enter the piping.
Disconnect the air conditioning tube and accessory assembly.
Clean off any foreign matter on and near the ends of the air conditioning tube and accessory assembly and cooler condenser assembly.
Remove the 2 O-rings from the air conditioning tube and accessory assembly.
Wrap the open ends of the separated cooler condenser assembly and air conditioning tube and accessory assembly with vinyl tape to prevent entry of moisture and foreign matter.
Remove the piping clamp.
53205
16.REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY
88460
17.REMOVE COOLER CONDENSER ASSEMBLY
|
Remove in this Direction |
Disengage the 2 claws and 2 guides, and remove the cooler condenser assembly as shown in the illustration.
Do not damage the cooler condenser assembly or radiator assembly when removing the cooler condenser assembly.