1. PRECAUTION
When replacing the radio and display receiver assembly or navigation ECU, always replace it with a new one. If a radio and display receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:
A communication malfunction DTC may be stored.
The radio and display receiver assembly or navigation ECU may not operate normally.
After replacing the navigation ECU, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the radio and display receiver assembly.
86841
2.INSTALL NAVIGATION ECU
86140A
3.INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY
86212C
4.INSTALL NO. 2 RADIO RECEIVER BRACKET
86211J
5.INSTALL NO. 1 RADIO RECEIVER BRACKET
86842
6.INSTALL NO. 1 NAVIGATION WIRE
Connect the 3 connectors to install the No. 1 navigation wire.
86453
7.INSTALL MULTI-MEDIA MODULE WIRE
8.INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET
55670
9.INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY
55480D
10.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
55012A
11.INSTALL NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY
55435B
12.INSTALL NO. 1 METER HOOD CLUSTER
13. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (for Power Tilt and Power Telescopic Steering Column)