Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for eCall) › 2019.02–2021.02
RM33C0E _56 Audio / Visual / Telematics _078700 TELEMATICS _0387130 TELEMATICS SYSTEM(for eCall) C

TELEMATICS  TELEMATICS SYSTEM(for eCall)  B1572  Microphone Error  


DESCRIPTION

This DTC is stored when a communication telematics box signal line is disconnected.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1572 Microphone Error Current at terminal MCVD exceeds the malfunction threshold for 10 seconds or more while the power switch is on (IG)
·

Telematics transceiver

·

Communication telematics box

·

Harness or connector

·

Mayday wire



WIRING DIAGRAM

E288945E01
0.906,1.406 1.521,1.604 0.615,0.198 10 false MCMD 1.052,1.813 1.667,2.01 0.615,0.198 10 false SP+ 1.063,2.219 1.677,2.417 0.615,0.198 10 false SP- 0.99,2.594 1.604,2.792 0.615,0.198 10 false MICV 0.948,2.99 1.563,3.188 0.615,0.198 10 false MIC1+ 0.948,3.375 1.563,3.573 0.615,0.198 10 false MIC2+ 1.042,3.792 1.656,3.99 0.615,0.198 10 false MCI- 5.802,1.396 6.417,1.594 0.615,0.198 10 false MCMD 5.813,1.781 6.427,1.979 0.615,0.198 10 false SP+ 5.823,2.198 6.438,2.396 0.615,0.198 10 false SP- 5.802,2.583 6.417,2.781 0.615,0.198 10 false MICV 5.802,3 6.417,3.198 0.615,0.198 10 false MCVD 5.802,3.365 6.417,3.563 0.615,0.198 10 false MCI+ 5.813,3.771 6.427,3.969 0.615,0.198 10 false MCI- 5.604,4.792 7.042,5.031 1.438,0.24 10 false Telematics Transceiver 3.823,3.969 4.688,4.219 0.865,0.25 10 false (Shielded) 0.375,4.75 1.438,5.156 1.063,0.406 10 false Communication Telematics Box 0.375,4.583 1.146,4.99 0.771,0.406 10 false P 2.01,1.302 2.625,1.5 0.615,0.198 10 false MCMD 2.146,1.698 2.76,1.896 0.615,0.198 10 false SP+ 2.188,2.104 2.802,2.302 0.615,0.198 10 false SP- 2.083,2.479 2.698,2.677 0.615,0.198 10 false MICV 2.031,2.896 2.646,3.094 0.615,0.198 10 false MCVD 2.104,3.281 2.719,3.479 0.615,0.198 10 false MCI+ 2.125,3.677 2.74,3.875 0.615,0.198 10 false MCI- 1.458,1.313 2.073,1.51 0.615,0.198 10 false 1 1.479,1.708 2.094,1.906 0.615,0.198 10 false 3 1.469,2.104 2.083,2.302 0.615,0.198 10 false 8 1.479,2.5 2.094,2.698 0.615,0.198 10 false 5 1.49,2.865 2.104,3.063 0.615,0.198 10 false 2 1.479,3.25 2.094,3.448 0.615,0.198 10 false 7 1.49,3.677 2.104,3.875 0.615,0.198 10 false 4 2.625,1.219 3.24,1.417 0.615,0.198 10 false 1 2.646,1.615 3.26,1.813 0.615,0.198 10 false 3 2.625,2 3.24,2.198 0.615,0.198 10 false 9 2.635,2.406 3.25,2.604 0.615,0.198 10 false 6 2.594,2.792 3.208,2.99 0.615,0.198 10 false 10 2.594,3.198 3.208,3.396 0.615,0.198 10 false 11 2.635,3.594 3.25,3.792 0.615,0.198 10 false 5 5.5,1.688 6.115,1.885 0.615,0.198 10 false 20 5.5,1.302 5.802,1.5 0.302,0.198 10 false 14 5.51,2.083 6.125,2.281 0.615,0.198 10 false 21 5.5,2.49 5.844,2.708 0.344,0.219 10 false 31 5.5,2.885 5.896,3.083 0.396,0.198 10 false 33 5.51,3.677 5.802,3.875 0.292,0.198 10 false 35 2.563,1.385 3.333,1.792 0.771,0.406 10 false V19 5.771,4.208 6.385,4.406 0.615,0.198 10 false SGND 5.51,4.094 5.823,4.292 0.313,0.198 10 false 32 1.698,4.625 2.469,5.031 0.771,0.406 10 false Mayday Wire 2.563,1.781 3.333,2.188 0.771,0.406 10 false V19 2.563,2.177 3.333,2.583 0.771,0.406 10 false V19 2.563,2.573 3.333,2.979 0.771,0.406 10 false V19 2.563,2.969 3.333,3.375 0.771,0.406 10 false V19 2.563,3.365 3.333,3.771 0.771,0.406 10 false V19 2.563,3.76 3.333,4.167 0.771,0.406 10 false V19 5.5,3.281 5.854,3.479 0.354,0.198 10 false 34 5.615,4.615 6.385,5.021 0.771,0.406 10 false K157

CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Registration for Telematics System.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for eCall)>REGISTRATION


PROCEDURE

1.CHECK DTC
a.

Turn the power switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the power switch on (IG) and wait for 10 seconds or more.


d.

Turn the GTS on.


e.

Clear the DTCs.

Body Electrical > Telematics > Clear DTCs
50002 233

f.

Check for DTCs and check that no DTCs are output.

Body Electrical > Telematics > Trouble Codes
50001 233
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

NG

2.INSPECT TELEMATICS TRANSCEIVER
2.INSPECT TELEMATICS TRANSCEIVER
a.
B518361C02
1.385,1.833 1.604,1.313 false 0.823,1.615 1.26,1.313 false 0.083,0.094 0.438,0.385 0.354,0.292 10 false *a 0.531,1.635 1.063,1.875 0.531,0.24 10 false MCI- 1.031,1.865 1.563,2.104 0.531,0.24 10 false MICV
*a Component with harness connected
(Telematics Transceiver)


Measure the voltage and resistance according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
31 (MICV) - Body ground Power switch on (ACC) 4 to 6 V


Standard Resistance:
Tester Connection Condition Specified Condition
35 (MCI-) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - MAYDAY WIRE)

NG

6.REPLACE TELEMATICS TRANSCEIVER
3.CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - MAYDAY WIRE)
a.

Disconnect the K157 telematics transceiver connector.


b.

Disconnect the V19 mayday wire connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
K157-14 (MCMD) - V19-1 (MCMD) Always Below 1 Ω
K157-20 (SP+) - V19-3 (SP+) Always Below 1 Ω
K157-21 (SP-) - V19-9 (SP-) Always Below 1 Ω
K157-31 (MICV) - V19-6 (MICV) Always Below 1 Ω
K157-33 (MCVD) - V19-10 (MCVD) Always Below 1 Ω
K157-34 (MCI+) - V19-11 (MCI+) Always Below 1 Ω
K157-35 (MCI-) - V19-5 (MCI-) Always Below 1 Ω
K157-14 (MCMD) or V19-1 (MCMD) - Body ground Always 10 kΩ or higher
K157-20 (SP+) or V19-3 (SP+) - Body ground Always 10 kΩ or higher
K157-21 (SP-) or V19-9 (SP-) - Body ground Always 10 kΩ or higher
K157-31 (MICV) or V19-6 (MICV) - Body ground Always 10 kΩ or higher
K157-33 (MCVD) or V19-10 (MCVD) - Body ground Always 10 kΩ or higher
K157-34 (MCI+) or V19-11 (MCI+) - Body ground Always 10 kΩ or higher
K157-35 (MCI-) or V19-5 (MCI-) - Body ground Always 10 kΩ or higher
K157-32 (SGND) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

4.CHECK MAYDAY WIRE (COMMUNICATION TELEMATICS BOX - WIRE HARNESS)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK MAYDAY WIRE (COMMUNICATION TELEMATICS BOX - WIRE HARNESS)
a.

Disconnect the V19 wire harness connector.


b.

Disconnect the P communication telematics box connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
V19-1 (MCMD) - P-1 (MCMD) Always Below 1 Ω
V19-3 (SP+) - P-3 (SP+) Always Below 1 Ω
V19-9 (SP-) - P-8 (SP-) Always Below 1 Ω
V19-6 (MICV) - P-5 (MICV) Always Below 1 Ω
V19-10 (MCVD) - P-2 (MIC1+) Always Below 1 Ω
V19-11 (MCI+) - P-7 (MIC2+) Always Below 1 Ω
V19-5 (MCI-) - P-4 (MCI-) Always Below 1 Ω
V19-1 (MCMD) or P-1 (MCMD) - Body ground Always 10 kΩ or higher
V19-3 (SP+) or P-3 (SP+) - Body ground Always 10 kΩ or higher
V19-9 (SP-) or P-8 (SP-) - Body ground Always 10 kΩ or higher
V19-6 (MICV) or P-5 (MICV) - Body ground Always 10 kΩ or higher
V19-10 (MCVD) or P-2 (MIC1+) - Body ground Always 10 kΩ or higher
V19-11 (MCI+) or P-7 (MIC2+) - Body ground Always 10 kΩ or higher
V19-5 (MCI-) or P-4 (MCI-) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

5.REPLACE COMMUNICATION TELEMATICS BOX

NG

5.REPLACE COMMUNICATION TELEMATICS BOX
a.

Replace the communication telematics box with a new or known good one.

Click hereAudio / Visual / Telematics>TELEMATICS>COMMUNICATION TELEMATICS BOX>REMOVAL


b.

Clear the DTCs.

Body Electrical > Telematics > Clear DTCs
50002 233

c.

Recheck for DTCs and check that no DTCs are output.

Body Electrical > Telematics > Trouble Codes
50001 233
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

END

NG

REPLACE COMMUNICATION TELEMATICS BOX

6.REPLACE TELEMATICS TRANSCEIVER
a.

Replace the telematics transceiver with a new one.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL


Result:
Proceed to
NEXT



NEXT