The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during radiator assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
| Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
| Headlight ECU sub-assembly LH
|
·
Synchronize the vehicle information
·
Perform headlight ECU sub-assembly LH initialization
|
Lighting system (EXT)
|
( )
|
·
Swing grill actuator assembly
·
Radiator shutter sub-assembly
|
Change grille shutter control mode and/or perform initialization
|
Grille shutter system
|
( )
|
| Front bumper assembly
|
·
Measure ultrasonic sensor detection angle
·
Ultrasonic sensor detection angle registration
|
Parking Support Brake System
|
( )
|
w/ Parking Support Brake System
|
·
Measure ultrasonic sensor detection angle
·
Ultrasonic sensor detection angle registration
|
TOYOTA Parking Assist-sensor System
|
( )
|
| Parking Support Brake System
|
( )
|
w/o Parking Support Brake System
|
Initialization of ultrasonic sensors
|
TOYOTA Parking Assist-sensor System
|
( )
|