Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › GRILLE SHUTTER › 2019.02–2020.08
RM33C0E _59 Vehicle Exterior _065474 EXTERIOR PANELS / TRIM _0328324 GRILLE SHUTTER A

EXTERIOR PANELS / TRIM  GRILLE SHUTTER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during grille shutter removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly (w/ Parking Support Brake System)
·

Measure ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


·

TOYOTA Parking Assist-sensor System

·

Parking Support Brake System


(Click here)
·

Swing grill actuator assembly

·

Radiator shutter sub-assembly


Change grille shutter control mode and/or perform initialization Grille Shutter system (Click here)

PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

Hide 16691A 2.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE RH (for Type A)

a.
B484472

Disengage the 2 claws to remove the front radiator side air guide plate RH.


Hide 16691A 3.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE RH (for Type B)

a.
B479947

Disengage the 2 claws to remove the front radiator side air guide plate RH.


Hide 16695A 4.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE LH (for Type A)

a.
B484473

Disengage the 2 claws to remove the front radiator side air guide plate LH.


Hide 16695A 5.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE LH (for Type B)

a.
E371116

Disengage the 2 claws to remove the front radiator side air guide plate LH.


Hide 53019F 7.REMOVE RADIATOR SHUTTER SUB-ASSEMBLY (for Type A)

a.
B481964

Disconnect the connector.


b.

Disengage the clamp.


c.

Remove the 3 bolts.

B479950


d.
B481966C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 2 guides to remove the radiator shutter sub-assembly as shown in the illustration.


Hide 53019F 8.REMOVE RADIATOR SHUTTER SUB-ASSEMBLY (for Type B)

a.
B479949

Disconnect the connector.


b.

Remove the 3 bolts.

B479950


c.
B479951C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 2 guides to remove the radiator shutter sub-assembly as shown in the illustration.