Home › Vehicle Exterior › DOOR / HATCH › REAR DOOR › 2019.02–2021.02
RM33C0E _59 Vehicle Exterior _065469 DOOR / HATCH _0333682 REAR DOOR A

DOOR / HATCH  REAR DOOR  DISASSEMBLY  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear door removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*: When performing learning using the GTS

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane Departure Alert System (w/ Steering Control) (Click here)
Parking Support Brake System*
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
·

Door window regulator sub-assembly

·

Door glass

·

Door glass run


Initialize Power Window Control System
·

Auto up and down function

·

Jam protection function

·

Remote control function

·

Key-linked function

·

Wireless transmitter-linked function

·

Key-off operation function

·

Catch protection function

·

Window open warning function


(Click here)

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 64718C 2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER

Hide 3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 74038B 4.REMOVE REAR DOOR ARMREST COVER SUB-ASSEMBLY

a.
B471489

Using a moulding remover, disengage the 3 claws to remove the rear door armrest cover sub-assembly.


Hide 5.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL

a.
B471491C01
0,0 0,0 false
V113146

Place Hand Here
V113147

Remove in this Direction


Disengage the 2 clips, 5 claws and 6 guides as shown in the illustration.


b.

Disconnect the connector to remove the rear power window regulator switch assembly with rear door upper armrest base panel.


Hide 74260 6.REMOVE REAR ARMREST ASSEMBLY

a.
B471493C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 3 clips, 8 claws and 2 guides as shown in the illustration.


b.
B471495C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the guide to remove the rear armrest assembly as shown in the illustration.


Hide 67604 7.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

a.
B471497C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape to the rear door panel as shown in the illustration.


b.
B471498

Remove the 3 screws.


c.
B471499C01
0,0 0,0 false
V113146

Place Hand Here
V113147

Remove in this Direction


Disengage the 7 clips as shown in the illustration.


d.
B471500C01
0,0 0,0 false
V113147

Remove in this Direction


Pull out the rear door trim board sub-assembly as shown in the illustration to disengage the guide.


e.

Raise the rear door trim board sub-assembly to separate the rear door trim board sub-assembly with the rear door inner glass weatherstrip and No. 1 door scuff plate clamp.


f.
B471501C01
2.26,1.083 2.656,0.771 true 2.448,1.802 2.167,1.458 true 2.667,0.688 2.917,0.885 0.25,0.198 10 true *1 2.458,1.729 2.708,1.927 0.25,0.198 10 true *2
*1 Rear Door Inside Locking Cable Assembly
*2 Rear Door Lock Remote Control Cable Assembly
V113147

Remove in this Direction


Disconnect the rear door lock remote control cable assembly and rear door inside locking cable assembly to remove the rear door trim board sub-assembly as shown in the illustration.


g.
B471504

Using a screwdriver, disengage the claw to remove the No. 1 door scuff plate clamp from the rear door trim board sub-assembly.


Hide 68174A 8.REMOVE REAR DOOR INNER GLASS WEATHERSTRIP

a.
B471505C01
0,0 0,0 false
V113147

Remove in this Direction


Slide the rear door inner glass weatherstrip to remove it from the rear door trim board sub-assembly as shown in the illustration.


Hide 65907E 9.REMOVE REAR CURTAIN SUB-ASSEMBLY (w/ Rear Door Sunshade)

a.
B488903

Remove the 9 screws.


b.

Disengage the 3 guides to remove the rear curtain sub-assembly.


Hide 67844A 10.REMOVE REAR DOOR NO. 2 SERVICE HOLE COVER

a.
B477386

Disengage the clip.


b.
B471521

Remove the rear door No. 2 service hole cover.


Hide 69206C 11.REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY

a.
B471508

Disengage the 3 claws to remove the rear door inside handle sub-assembly.


Hide 86160B 12.REMOVE REAR SPEAKER ASSEMBLY

Hide 67674A 13.REMOVE REAR DOOR FRAME GARNISH

a.
B471509

Disengage the 2 claws to remove the rear door frame garnish.


Hide 67842E 14.REMOVE REAR DOOR SERVICE HOLE COVER

a.
B471510

Disconnect the connector.


b.

Disengage the 2 clamps.


c.
B471511

Disengage the 8 clips to remove the rear door service hole cover.


Hide 67848A 15.REMOVE REAR DOOR NO. 1 VENT SEAL

a.
B471512

Remove the rear door No. 1 vent seal.


Hide 67858B 16.REMOVE REAR DOOR PANEL PROTECTOR

a.
B477385

Disengage the clip.


b.
B471514

Remove the rear door panel protector.


Hide 68152C 17.REMOVE REAR DOOR GLASS RUN

a.
B471518

Remove the rear door glass run.


Hide 68640A 18.REMOVE REAR DOOR CHECK ASSEMBLY

a.
B471519C01
0,0 0,0 false
V100135

Nut
V100136

Bolt


Remove the 2 nuts, bolt and rear door check assembly.


Hide 67872 19.REMOVE REAR DOOR WEATHERSTRIP

a.
B471522C01
0.563,0.979 1.01,0.865 true 1.031,0.75 1.344,0.948 0.313,0.198 10 true *a
*a Double-sided Tape


Using a clip remover, disengage the 23 clips and remove the rear door weatherstrip.


Hide 67408F 20.REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY

a.
B471523C01
0,0 0,0 false
V100135

Screw
V100136

Bolt


Remove the screw, 2 bolts and rear door rear lower window frame sub-assembly.


Hide 68124B 21.REMOVE REAR DOOR QUARTER WINDOW GLASS

a.
B471724C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the rear door quarter window glass with rear door quarter window weatherstrip as shown in the illustration.


b.

Remove the rear door quarter window glass from the rear door quarter window weatherstrip.


Hide 68104 22.REMOVE REAR DOOR GLASS SUB-ASSEMBLY

a.
B471526

Separate the rear door glass sub-assembly from the rear door window regulator assembly as shown in the illustration.

NOTICE:

After separating the rear door glass sub-assembly, do not allow it to fall.



b.
B471643C01
0,0 0,0 false
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


Remove the rear door glass sub-assembly as indicated by the arrows, in the order shown in the illustration.

NOTICE:

Do not damage the rear door glass sub-assembly.



Hide 69906B 23.REMOVE REAR DOOR GLASS CHANNEL SUB-ASSEMBLY

a.
B471645C01
0.74,1.042 1.156,1.24 false 0.583,0.938 0.896,1.135 0.313,0.198 10 false *a
*a Protective Tape


Using a screwdriver, remove the rear door glass channel sub-assembly.

HINT:

Tape the screwdriver tip before use.



Hide 69975A 24.REMOVE REAR DOOR GLASS CHANNEL FILLER

a.

Remove the rear door glass channel filler from the rear door glass sub-assembly.


Hide 25.REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY

a.

Disconnect the connector.


b.
B471648C01
0.906,0.313 1.479,0.438 true 0.667,0.198 0.917,0.417 0.25,0.219 10 true *a
*a Temporary Bolt


Loosen the temporary bolt.

NOTICE:

Do not remove the temporary bolt. If the temporary bolt is removed, the rear door window regulator assembly may fall and cause damage.



c.

Remove the 3 bolts and rear door window regulator assembly.


d.

Remove the temporary bolt from the rear door window regulator assembly.


Hide 69060A 26.REMOVE REAR DOOR LOCK WITH MOTOR ASSEMBLY

Hide 69240 27.REMOVE REAR DOOR OUTSIDE HANDLE ASSEMBLY

a.
B471650C01
0,0 0,0 false
V113147

Disengage in this Direction


Disengage the 2 claws and move the lever as shown in the illustration.


b.
B471652C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the rear door outside handle assembly as shown in the illustration.


Hide 69227L 28.REMOVE REAR DOOR OUTSIDE HANDLE COVER

a.
B471654

Using a T30 "TORX" socket wrench, loosen the screw.

HINT:

The screw cannot be removed because it is integrated into the rear door outside handle frame sub-assembly.



b.

Disengage the claw to remove the rear door outside handle cover.


Hide 69241G 29.REMOVE REAR DOOR FRONT OUTSIDE HANDLE PAD

a.
B471655

Disengage the 3 claws to remove the rear door front outside handle pad.


Hide 69242G 30.REMOVE REAR DOOR REAR OUTSIDE HANDLE PAD

a.
B471656

Disengage the claw and 3 guides to remove the rear door rear outside handle pad.


Hide 69204A 31.REMOVE REAR DOOR OUTSIDE HANDLE FRAME SUB-ASSEMBLY

a.
B471657C01
0.052,0.052 0.427,0.354 0.375,0.302 12 true *A 0.052,2.563 0.427,2.885 0.375,0.323 12 true *B
*A Inside
*B Outside


Using a T30 "TORX" socket wrench, remove the screw.


b.

Slide the rear door outside handle frame sub-assembly as shown in the illustration to disengage the claw and then remove it.


Hide 65923E 32.REMOVE CURTAIN HOOK (w/ Rear Door Sunshade)

a.
B481254C01
1.021,2.563 1.375,2.927 true 2.49,2.771 2.792,3.01 true 1.417,2.885 1.729,3.042 0.313,0.156 10 false *a 2.813,2.948 3.125,3.104 0.313,0.156 10 false *a
*a Protective Tape
V113147

Remove in this Direction


Using a screwdriver with its tip wrapped with protective tape, push out the pin as shown in the illustration.


b.
B481255C01
0.51,2.844 0.729,2.656 false 2.271,3.167 2.49,3 false 0.344,2.76 0.656,2.917 0.313,0.156 10 false *a 2.115,3.094 2.427,3.25 0.313,0.156 10 false *a
*a Protective Tape
V113147

Remove in this Direction


Using a screwdriver with its tip wrapped with protective tape, disengage the pin.


c.
B488901C01
0,0 0,0 false
V100135

Push


Disengage the 4 claws to remove the 2 curtain hooks as shown in the illustration.


Hide 67003C 33.REMOVE REAR DOOR PANEL CUSHION

a.
B471659

Disengage the 4 claws to remove the 2 rear door panel cushions.


Hide 67888F 34.REMOVE REAR DOOR NO. 2 WEATHERSTRIP

a.
B471660

Disengage the 5 clips to remove the rear door No. 2 weatherstrip.


Hide 75740 35.REMOVE REAR DOOR BELT MOULDING ASSEMBLY

Hide 75792 36.REMOVE DOOR WINDOW FRAME MOULDING CLIP

a.
B469810C01
2.458,1.281 2.094,1.052 true 2.479,1.208 2.729,1.438 0.25,0.229 10 true *a
*a Protective Tape
V113147

Remove in this Direction


Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws to remove the door window frame moulding clip.


Hide 75762A 37.REMOVE REAR DOOR FRONT WINDOW FRAME MOULDING

Hide 67846A 38.REMOVE REAR DOOR FRONT OUTSIDE SEAL

a.
B471662

Disengage the guide to remove the rear door front outside seal.


Hide 75708 39.REMOVE REAR DOOR WINDOW FRAME MOULDING SUB-ASSEMBLY

Hide 75978H 40.REMOVE REAR DOOR LOWER OUTSIDE STRIPE

Hide 75988C 41.REMOVE REAR DOOR OUTSIDE STRIPE