Home › Drivetrain › P710 (HYBRID TRANSMISSION / TRANSAXLE) › SHIFT LEVER › from 2019.10
RM33C0E _52 Drivetrain _065428 P710 HYBRID TRANSMISSION / TRANSAXLE _0319556 SHIFT LEVER A

P710 HYBRID TRANSMISSION / TRANSAXLE  SHIFT LEVER  REMOVAL  


PROCEDURE

Hide 1.SECURE VEHICLE

a.

Fully apply the parking brake and chock a wheel.

CAUTION:
C332327

·

Make sure to apply the parking brake and chock a wheel before performing this procedure.

·

If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.




Hide 33554C 2.REMOVE SHIFT LOCK RELEASE BUTTON COVER

a.
C370818C01
1.083,1.021 1.667,1.021 true 0.844,0.906 1.063,1.104 0.219,0.198 10 true *a
*a Protective Tape


Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and guide to remove the shift lock release button cover from the rear upper console panel sub-assembly.

NOTICE:

Be careful not to damage the shift lock release button cover and rear upper console panel sub-assembly.



Hide 33504F 3.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

Hide 33820B 5.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Move the shift lever to N.


b.
C413140

Disconnect the transmission control cable assembly from the transmission floor shift assembly.


c.
C413141C01
1.052,2.469 1.229,2.667 0.177,0.198 10 true *a
*a Counterclockwise


Rotate the lock nut counterclockwise approximately 180° and, while holding the lock nut in that position, disconnect the transmission control cable assembly from the transmission floor shift assembly.


Hide 6.REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY

a.
C380394

Remove the 4 bolts.


b.
C380395

Remove the clip to disconnect the No. 1 console box duct from the transmission floor shift assembly.


c.
C380396

Disconnect the transmission control switch connector.


d.

Disengage the clamp to disconnect the wire harness from the transmission floor shift assembly.


e.
C380397

Disconnect the shift lock control ECU connector.


f.

Disengage the clamp to disconnect the wire harness from the transmission floor shift assembly.


g.

Remove the transmission floor shift assembly.