Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › GRILLE SHUTTER › 2020.08–2021.02
RM33C0E _59 Vehicle Exterior _065474 EXTERIOR PANELS / TRIM _0328324 GRILLE SHUTTER A

EXTERIOR PANELS / TRIM  GRILLE SHUTTER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during grille shutter removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly (w/ Parking Support Brake System)
·

Measure ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


·

TOYOTA Parking Assist-sensor System

·

Parking Support Brake System


(Click here)
Radiator shutter assembly Change grille shutter control mode and/or perform initialization Grille Shutter system (Click here)(w/ Canister Pump Module)
(Click here)(w/o Canister Pump Module)

PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

Hide 16691A 2.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE RH

a.
B592575

Disengage the 2 claws to remove the front radiator side air guide plate RH.


Hide 16695A 3.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE LH

a.
E371116

Disengage the 2 claws to remove the front radiator side air guide plate LH.


Hide 53019F 5.REMOVE RADIATOR SHUTTER SUB-ASSEMBLY

a.
B592576

Disconnect the connector.


b.

Remove the 3 bolts.

B592577


c.
B592578C02
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 2 guides to remove the radiator shutter sub-assembly as shown in the illustration.