Home › Vehicle Interior › HEATING / AIR CONDITIONING › AMBIENT TEMPERATURE SENSOR › from 2021.02
RM33C0E _58 Vehicle Interior _065464 HEATING / AIR CONDITIONING _0331716 AMBIENT TEMPERATURE SENSOR A

HEATING / AIR CONDITIONING  AMBIENT TEMPERATURE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during thermistor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link

*: Applies only for when removing and installing or replacing the rear television camera assembly.

Front bumper assembly (w/ Parking Support Brake System)
·

Measure ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking Support Brake System (Click here)
Front bumper assembly (w/ Panoramic View Monitor System) Front television camera view adjustment Panoramic View Monitor System (Click here)for Initialization
(Click here)for Calibration
Replacement or removal and installation of 2 or more parts:
·

Front television camera assembly, front bumper assembly or radiator grille

·

Rear television camera assembly

·

Side television camera assembly LH or outer rear view mirror assembly LH

·

Side television camera assembly RH or outer rear view mirror assembly RH


·

Television camera view adjustment

·

Rear television camera assembly optical axis (Back camera position setting)*


Panoramic View Monitor System (Click here)for Initialization
(Click here)for Calibration

PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

Hide 16691A 2.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE RH (w/o Grille Shutter)

a.
E462193

Disengage the 2 claws to remove the front radiator side air guide plate RH.


Hide 88790B 3.REMOVE THERMISTOR ASSEMBLY (w/o Grille Shutter)

a.
E462194

Disengage the clamp.


b.

Disconnect the connector to remove the thermistor assembly.


Hide 16695A 4.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE LH (w/ Grille Shutter)

a.
E460706

Disengage the 2 claws to remove the front radiator side air guide plate LH.


Hide 88790B 5.REMOVE THERMISTOR ASSEMBLY (w/ Grille Shutter)

a.
E460707

Disengage the clamp.


b.

Disconnect the connector to remove the thermistor assembly.