Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ECU › from 2021.02
RM33C0E _59 Vehicle Exterior _065472 LIGHTING (EXT) _0330509 HEADLIGHT ECU A

LIGHTING (EXT)  HEADLIGHT ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight ECU sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link

*: Applies only for when removing and installing or replacing the rear television camera assembly.

Headlight ECU sub-assembly LH
·

Synchronize the vehicle information

·

Perform headlight ECU sub-assembly LH initialization


Lighting System (EXT) (w/ Automatic Headlight Beam Level Control System) (Click here)
Front bumper assembly (w/ Parking Support Brake System)
·

Measure ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking Support Brake System (Click here)
Front bumper assembly (w/ Panoramic View Monitor System) Front television camera view adjustment Panoramic View Monitor System (Click here)
Replacement or removal and installation of 2 or more parts:
·

Front television camera assembly, front bumper assembly or radiator grille

·

Rear television camera assembly

·

Side television camera assembly LH or outer rear view mirror assembly LH

·

Side television camera assembly RH or outer rear view mirror assembly RH


·

Television camera view adjustment

·

Rear television camera assembly optical axis (Back camera position setting)*



HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 81056A 2.REMOVE HEADLIGHT ECU SUB-ASSEMBLY

NOTICE:
·

Make sure to replace the headlight gasket with a new one. Failure to do so may cause water ingress.

·

If the headlight ECU sub-assembly has been struck or dropped, replace it with a new one.



a.
E371271

Remove the 3 screws.


b.
E371272

Separate the connector cover from the headlight ECU sub-assembly.


c.
E371273

Disconnect the connector to remove the headlight ECU sub-assembly.


Hide 81134 3.REMOVE HEADLIGHT GASKET

NOTICE:

Make sure to replace the headlight gasket with a new one. Failure to do so may cause water ingress.


a.
E371274

Remove the headlight gasket.